Electronic Components Datasheet Search |
|
HY27UF081G2M-VIS Datasheet(PDF) 8 Page - Hynix Semiconductor |
|
HY27UF081G2M-VIS Datasheet(HTML) 8 Page - Hynix Semiconductor |
8 / 48 page Rev 0.7 / Apr. 2005 8 Preliminary HY27UF(08/16)1G2M Series HY27SF(08/16)1G2M Series 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash 1.2 PIN DESCRIPTION Pin Name Description IO0-IO7 IO8-IO15(1) DATA INPUTS/OUTPUTS The IO pins allow to input command, address and data and to output data during read / program operations. The inputs are latched on the rising edge of Write Enable (WE#). The I/O buffer float to High-Z when the device is deselected or the outputs are disabled. CLE COMMAND LATCH ENABLE This input activates the latching of the IO inputs inside the Command Register on the Rising edge of Write Enable (WE#). ALE ADDRESS LATCH ENABLE This input activates the latching of the IO inputs inside the Address Register on the Rising edge of Write Enable (WE#). CE# CHIP ENABLE This input controls the selection of the device. When the device is busy CE# low does not deselect the memory. WE# WRITE ENABLE This input acts as clock to latch Command, Address and Data. The IO inputs are latched on the rise edge of WE#. RE# READ ENABLE The RE# input is the serial data-out control, and when active drives the data onto the I/O bus. Data is valid tREA after the falling edge of RE# which also increments the internal column address counter by one. WP# WRITE PROTECT The WP# pin, when Low, provides an Hardware protection against undesired modify (program / erase) operations. RB# READY BUSY The Ready/Busy output is an Open Drain pin that signals the state of the memory. VCC SUPPLY VOLTAGE The VCC supplies the power for all the operations (Read, Write, Erase). VSS GROUND NC NOT CONNECTED PRE To Enable Power On Auto Read. When PRE is a logic high, Power on Auto Read mode is enabled, and when PRE is a logic low, Power Auto Read mode is disabled. Power On Auto Read mode is available only on 3.3V device. Not using POWER-ON AUTO-READ, connect it Vss or leave it N.C. Table 2: Pin Description NOTE: 1. For x16 version only 2. A 0.1uF capacitor should be connected between the VCC Supply Voltage pin and the VSS Ground pin to decouple the current surges from the power supply. The PCB track widths must be sufficient to carry the currents required during program and erase operations. |
Similar Part No. - HY27UF081G2M-VIS |
|
Similar Description - HY27UF081G2M-VIS |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.NET |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |