GENERAL DATA
Life Expectancy
Minimum operations
Mechanical
1 x 107
Electrical
1 x 105 at 10 A 250 VAC Res.
Operate Time (typical)
8 ms at nominal coil voltage
Release Time (typical)
5 ms at nominal coil voltage
(with no coil suppression)
Dielectric Strength
5000 Vrms coil to contact
(at sea level for 1 min.) 1000 Vrms between open contacts
Insulation
1000 megohms min. at 20°C, 500 VDC
Resistance
50% RH
Dropout
Greater than 10% of nominal coil voltage
Ambient Temperature
At nominal coil voltage
Operating
-40°C (-40°F) to 85°C (185°F)
Storage
-40°C (-40°F) to 105°C (221°F)
Vibration
0.062" (1.5 mm) DA at 10–55 Hz
Shock
10 g
Enclosure
P.B.T. polyester
Terminals
Tinned copper alloy, P. C.
Max. Solder Temp.
270°C (518°F)
Max. Solder Time
5 seconds
Max. Solvent Temp.
80°C (176°F)
Max. Immersion Time
30 seconds
Weight
18 grams
Packing unit in pcs
50 per plastic tray / 500 per carton box
CONTACTS
Arrangement
SPST (1 Form A)
SPDT (1 Form C)
Ratings
Resistive load:
Max. switched power: 300 W or 2500 VA
Max. switched current: 10 A
Max. switched voltage: 150 VDC* or 380 VAC
*
Note: If switching voltage is greater than 30 VDC,
special precautions must be taken.
Please contact the factory.
Rated Load
UL, CUR
TV-5 120 AC
10 A 277 VAC
10 A 30 VDC resistive
1
/3 HP 250 VAC
1
/4 HP 125 VAC N. O.
TÜV
10 A 250 VAC, 30 VDC resistive, 100k cycles
Material
Silver cadmium oxide
Resistance
< 50 milliohms initially
ZETTLER electronics GmbH
Fax +49 89 800 97 200
www.ZETTLERelectronics.com
office@ZETTLERelectronics.com
0
97
800
89
+49
Tel.
Germany
Puchheim,
D-82178
Junkersstrasse 3,
2005-03-08
AZ697
COIL
Power
At Pickup Voltage
257 mW
(typical)
Max. Continuous
1.9 W at 20°C (68°F) ambient
Dissipation
Temperature Rise
34°C (61°F) nominal coil voltage
Temperature
Max. 130°C (266°F)
NOTES
1. All values at 20°C (68°F).
2. Relay may pull in with less than “Must Operate” value.
3. Specifications subject to change without notice.
10 AMP MINIATURE
POWER RELAY
FEATURES
• Dielectric strength 5000 Vrms
• 10 Amp switching — single pole contacts
• UL TV-5
• Isolation spacing greater than 8mm (1 Form A)
6mm (1 Form C)
• Epoxy sealed version available
• UL, CUR file E44211
• TÜV file R9659061