1

Rev. A

05/02/06

IS93C56A

IS93C66A

Copyright © 2006 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time

without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to

obtain the latest version of this device specification before relying on any published information and before placing orders for products.

2K-BIT/4K-BIT SERIAL ELECTRICALLY

ERASABLE PROM

MAY 2006

FUNCTIONAL BLOCK DIAGRAM

CS

SK

DUMMY

BIT

R/W

AMPS

DATA

REGISTER

ADDRESS

REGISTER

ADDRESS

DECODER

WRITE

ENABLE

HIGH VOLTAGE

GENERATOR

INSTRUCTION

DECODE,

CONTROL,

AND

CLOCK

GENERATION

EEPROM

ARRAY

256/512x8

128/256x16

INSTRUCTION

REGISTER

FEATURES

• Industry-standard Microwire Interface

— Non-volatile data storage

— Wide voltage operation:

Vcc = 1.8V to 5.5V

— Auto increment for efficient data dump

• User Configured Memory Organization

— By 16-bit or by 8-bit

• Hardware and software write protection

— Defaults to write-disabled state at power-up

— Software instructions for write-enable/disable

technology

• Versatile, easy-to-use Interface

— Self-timed programming cycle

— Automatic erase-before-write

— Programming status indicator

— Word and chip erasable

— Chip select enables power savings

• Durable and reliable

— 40-year data retention after 1M write cycles

— 1 million write cycles

— Unlimited read cycles

— Schmitt-trigger inputs

• Industrial and Automotive Temperature Grade

• Lead-free available

DESCRIPTION

The IS93C56A/66A are 2kb/4kb non-volatile,

an enhanced CMOS design and process. The

IS93C56A/66A contain power-efficient read/write

memory, and organization of either 256/512 bytes

of 8 bits or 128/256 words of 16 bits. When the

ORG pin is connected to Vcc or left unconnected,

x16 is selected; when it is connected to ground,

x8 is selected. The IS93C56A/66A are fully

backward compatible with IS93C56/66.

An instruction set defines the operation of the

devices, including read, write, and mode-enable

functions. To protect against inadvertent data

modification, all erase and write instructions are

accepted only while the devices are write-enabled.

A selected x8 byte or x16 word can be modified

with a single WRITE or ERASE instruction.

Additionally, the two instructions WRITE ALL or

ERASE ALL can program an entire array. Once a

device begins its self-timed program procedure,

the data out pin (Dout) can indicate the READY/

BUSY status by raising chip select (CS). The self-

timed write cycle includes an automatic erase-

before-write capability. The devices can output

any number of consecutive bytes/words using a

single READ instruction.