IRMCF343

This document is the property of International Rectifier and may not be copied or distributed without expressed consent.

4

1 Overview

IRMCF343 is a new International Rectifier integrated circuit device primarily designed as a

one-chip solution for complete inverter controlled appliance motor control applications. Unlike a

traditional microcontroller or DSP, the IRMCF343 provides a built-in closed loop sensorless

control sequencer and dual port RAM to map internal signal nodes. IRMCF343 also employs a

unique single shunt current reconstruction circuit to eliminate additional analog/digital circuitry

and enables a direct shunt resistor interface to the IC. Motion control programming is achieved

environment. Sequencing, user interface, host communication, and upper layer control tasks can be

implemented in the 8051 high-speed 8-bit microcontroller. The 8051 microcontroller is equipped

with a JTAG port to facilitate emulation and debugging tools. Figure 1 shows a typical application

schematic using the IRMCF343.

IRMCF343 is intended for development purpose and contains 48K bytes of RAM, which can be

loaded from external EEPROM for 8051 program execution. For high volume production,

IRMCK343 contains OTP ROM in place of program RAM to reduce the cost. Both IRMCF343

and IRMCK343 come in the same 64-pin QFP package with identical pin configuration to

facilitate PC board layout and transition to mass production

Figure 1.

Typical Application Block Diagram Using IRMCF343