FEB 12, 2007 revised to FEB 26, 2007

Page 1 of 13

www.power-one.com

FNP600/850/1000 AC-DC Front-Ends

& FNR-5-12/FNR-5-48 Power Shelves Data Sheet

Description

The FNP600/850/1000 power factor corrected (PFC) front ends provide (depending on model) either a 12 VDC or a 48 VDC

output for telecom, datacom, and other distributed power applications. Their small 1U by 2U size allows for configurations of

either height in hot-swap redundant systems while their internal fan and cooling design permits wide use with reliable operation.

Status is provided with front panel LEDs, logic signals, and via the I

enable the power supply, control fan speed, and on the 12 VDC models it allows for adjusting the output voltage from 7 to 12

VDC. This powerful feature allows the same power supply to be used in various applications where bus voltages driving isolated

dc-dc converters and POL regulators may be different.

Also, the FNP850-12R is uniquely designed with airflow from the rear of the power supply to the front. This airflow direction

supports those critical applications where space limitations and/or higher ambient temperatures near the rear of the rack system,

prohibit the discharge of higher temperature airflow from regular front-to-rear cooled power supplies.

The FNP600/850/1000's meet international safety requirements and are CE marked to the Low Voltage Directive (LVD).

Features

products are available

front-to-rear or from rear-to-front (-12R model)

Applications

600-to-5000-Watt

Front-End Power Solutions

I

can be controlled via Power-One's GUI-driven I

Management

software

and

an

I

interface (P/N HZZ02002G). An I

Manual

describes

the

complete

range

of

parameters that can be programmed to these

front-ends. This manual is available by searching

(600, 850, or 1000 Watts)

FNR-5 Power Shelf

FNR-5-48 Power Shelves provide up to 5000 watts in a 19" rack.

(See the Rack section for power shelf details.)