CY7C1338G
Document #: 38-05521 Rev. *D
Page 10 of 17
Switching Characteristics Over the Operating Range [11, 12, 13, 14, 15, 16]
Parameter
Description
–133
–100
Unit
Min.
Max.
Min.
Max.
tPOWER
VDD(Typical) to the first Access
[11]
11
ms
Clock
tCYC
Clock Cycle Time
7.5
10
ns
tCH
Clock HIGH
2.5
4.0
ns
tCL
Clock LOW
2.5
4.0
ns
Output Times
tCDV
Data Output Valid After CLK Rise
6.5
8.0
ns
tDOH
Data Output Hold After CLK Rise
2.0
2.0
ns
tCLZ
Clock to Low-Z[12, 13, 14]
00
ns
tCHZ
Clock to High-Z[12, 13, 14]
3.5
3.5
ns
tOEV
OE LOW to Output Valid
3.5
3.5
ns
tOELZ
OE LOW to Output Low-Z[12, 13, 14]
00
ns
tOEHZ
OE HIGH to Output High-Z[12, 13, 14]
3.5
3.5
ns
Setup Times
tAS
Address Set-up Before CLK Rise
1.5
2.0
ns
tADS
ADSP, ADSC Set-up Before CLK Rise
1.5
2.0
ns
tADVS
ADV Set-up Before CLK Rise
1.5
2.0
ns
tWES
GW, BWE, BWX Set-up Before CLK Rise
1.5
2.0
ns
tDS
Data Input Set-up Before CLK Rise
1.5
1.5
ns
tCES
Chip Enable Set-up
1.5
2.0
ns
Hold Times
tAH
Address Hold After CLK Rise
0.5
0.5
ns
tADH
ADSP, ADSC Hold After CLK Rise
0.5
0.5
ns
tWEH
GW, BWE, BWX Hold After CLK Rise
0.5
0.5
ns
tADVH
ADV Hold After CLK Rise
0.5
0.5
ns
tDH
Data Input Hold After CLK Rise
0.5
0.5
ns
tCEH
Chip Enable Hold After CLK Rise
0.5
0.5
ns
Notes:
11. This part has a voltage regulator internally; tPOWER is the time that the power needs to be supplied above VDD(minimum) initially before a read or write operation
can be initiated.
12. tCHZ, tCLZ,tOELZ, and tOEHZ are specified with AC test conditions shown in part (b) of AC Test Loads. Transition is measured ± 200 mV from steady-state voltage.
13. At any given voltage and temperature, tOEHZ is less than tOELZ and tCHZ is less than tCLZ to eliminate bus contention between SRAMs when sharing the same
data bus. These specifications do not imply a bus contention condition, but reflect parameters guaranteed over worst case user conditions. Device is designed
to achieve High-Z prior to Low-Z under the same system conditions.
14. This parameter is sampled and not 100% tested.
15. Timing reference level is 1.5V when VDDQ = 3.3V and is 1.25V when VDDQ = 2.5V.
16. Test conditions shown in (a) of AC Test Loads unless otherwise noted.
[+] Feedback
[+] Feedback
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
