This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc., www.essi.com.tw

or modifications due to changes in technical specifications.

10

EN25P32

Rev. C, Issue Date: 2007/10/18

being driven Low is an exact multiple of eight. For Page Program, if at any time the input byte is not a full

byte, nothing will happen and WEL will not be reset.

In the case of multi-byte commands of Page Program (PP), and Release from Deep Power Down

(RES ) minimum number of bytes specified has to be given, without which, the command will be

ignored.

In the case of Page Program, if the number of byte after the command is less than 4 (at least 1 data

byte), it will be ignored too. In the case of SE, exact 24-bit address is a must, any less or more will

cause the command to be ignored.

All attempts to access the memory array during a Write Status Register cycle, Program cycle or Erase

cycle are ignored, and the internal Write Status Register cycle, Program cycle or Erase cycle continues

unaffected.

Table 4. Instruction Set

Instruction Name

Byte 1

Code

Byte 2

Byte 3

Byte 4

Byte 5

Byte 6

n-Bytes

Write Enable

06h

Write Disable

04h

Read Status

Register

05h

(S7-S0)(1)

continuous

(2)

Write Status

Register

01h

S7-S0

Read Data

03h

A23-A16

A15-A8

A7-A0

(D7-D0)

(Next byte)

continuous

Fast Read

0Bh

A23-A16

A15-A8

A7-A0

dummy

(D7-D0)

(Next Byte)

continuous

Page Program

02h

A23-A16

A15-A8

A7-A0

D7-D0

(Next byte)

continuous

Sector Erase

D8h

A23-A16

A15-A8

A7-A0

Bulk Erase

C7h

Deep Power-down

B9h

Release from Deep

Power-down, and

read Device ID

dummy

dummy

dummy

(ID7-ID0)

(4)

Release from Deep

Power-down

ABh

Manufacturer/

Device ID

90h

dummy

dummy

00h(5)

(M7-M0)

(ID7-ID0)

Read Identification

9Fh

(M7-M0)

(ID15-ID8)

(ID7-ID0)

Enter OTP mode

3Ah

Notes:

1. Data bytes are shifted with Most Significant Bit first. Byte fields with data in parenthesis “( )” indicate data being read from

the device on the DO pin.

2. The Status Register contents will repeat continuously until CS# terminate the instruction.

3. All sectors may use any address within the sector.

4. The Device ID will repeat continuously until CS# terminate the instruction.

5. The Manufacturer ID and Device ID bytes will repeat continuously until CS# terminate the instruction.

00h on Byte 4 starts with MID and alternate with DID, 01h on Byte 4 starts with DID and alternate with MID.