CY7C0430BV
CY7C0430CV
Document #: 38-06027 Rev. *B
Page 7 of 37
CNTRDP1
CNTRDP2
CNTRDP3
CNTRDP4
Counter Readback Input. When asserted LOW, the
internal address value of the counter will be read back on
the address lines. During CNTRD operation, both CNTLD
and CNTINC must be HIGH. Counter readback operation
has higher priority over mask register readback operation.
Counter readback operation is independent of port chip
enables. If address readback operation occurs with chip
enables active (CE0 = LOW, CE1 = HIGH), the data lines
(I/Os) will be three-stated. The readback timing will be
valid after one no-operation cycle plus tCD2 from the rising
edge of the next cycle.
MKRDP1
MKRDP2
MKRDP3
MKRDP4
Mask Register Readback Input. When asserted LOW,
the value of the mask register will be readback on address
lines. During mask register readback operation, all
counter and MKLD inputs must be HIGH (see Counter
and Mask Register Operations truth table). Mask register
readback operation is independent of port chip enables.
If address readback operation occurs with chip enables
active (CE0 = LOW, CE1 = HIGH), the data lines (I/Os) will
be three-stated. The readback will be valid after one
no-operation cycle plus tCD2 from the rising edge of the
next cycle.
CNTINTP1
CNTINTP2
CNTINTP3
CNTINTP4
Counter Interrupt Flag Output. Flag is asserted LOW
for one clock cycle when the counter wraps around to
location zero.
INTP1
INTP2
INTP3
INTP4
Interrupt Flag Output. Interrupt permits communications
between all four ports. The upper four memory locations
can be used for message passing. Example of operation:
INTP4 is asserted LOW when another port writes to the
mailbox location of Port 4. Flag is cleared when Port 4
reads the contents of its mailbox. The same operation is
applicable to ports 1, 2, and 3.
TMS
JTAG Test Mode Select Input. It controls the advance of
JTAG TAP state machine. State machine transitions occur
on the rising edge of TCK.
TCK
JTAG Test Clock Input. This can be CLK of any port or
an external clock connected to the JTAG TAP.
TDI
JTAG Test Data Input. This is the only data input. TDI
inputs will shift data serially in to the selected register.
TDO
JTAG Test Data Output. This is the only data output.
TDO transitions occur on the falling edge of TCK. TDO
normally three-stated except when captured data is
shifted out of the JTAG TAP.
CLKBIST
BIST Clock Input.
GND
Thermal Ground for Heat Dissipation.
VSS
Ground Input.
VDD
Power Input.
VSS1
Address Lines Ground Input.
VDD1
Address Lines Power Input.
VSS2
Data Lines Ground Input.
VDD2
Data Lines Power Input.
Pin Definitions (continued)
Port 1
Port 2
Port 3
Port 4
Description
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
