M25PE10 datasheet(8/64 Pages) NUMONYX

Part #	M25PE10

Description	1 and 2 Mbit, page-erasable serial Flash memories with byte alterability, 75 MHz SPI bus, standard pinout

Download	64 Pages

Scroll/Zoom	100%

Manufacturer	NUMONYX [Numonyx B.V]

Direct Link	http://www.numonyx.com

Logo

8 / 64 page

Signal descriptions

M25PE20, M25PE10

8/64

2

Signal descriptions

2.1

Serial Data output (Q)

This output signal is used to transfer data serially out of the device. Data is shifted out on the

falling edge of Serial Clock (C).

2.2

Serial Data input (D)

This input signal is used to transfer data serially into the device. It receives instructions,

addresses, and the data to be programmed. Values are latched on the rising edge of Serial

Clock (C).

2.3

Serial Clock (C)

This input signal provides the timing of the serial interface. Instructions, addresses, or data

present at Serial Data input (D) are latched on the rising edge of Serial Clock (C). Data on

Serial Data output (Q) changes after the falling edge of Serial Clock (C).

2.4

Chip Select (S)

When this input signal is High, the device is deselected and Serial Data output (Q) is at high

impedance. Unless an internal Read, Program, Erase or Write cycle is in progress, the

device will be in the Standby Power mode (this is not the Deep Power-down mode). Driving

Chip Select (S) Low selects the device, placing it in the Active Power mode.

After power-up, a falling edge on Chip Select (S) is required prior to the start of any

instruction.

2.5

Reset (Reset)

The Reset (Reset) input provides a hardware reset for the memory.

When Reset (Reset) is driven High, the memory is in the normal operating mode. When

Reset (Reset) is driven Low, the memory will enter the Reset mode. In this mode, the output

is high impedance.

Driving Reset (Reset) Low while an internal operation is in progress will affect this operation

(write, program or erase cycle) and data may be lost.

2.6

Top Sector Lock (TSL)

This input signal puts the device in the Hardware Protected mode, when Top Sector Lock

(TSL) is connected to VSS, causing the top 256 pages (upper addresses) of the memory to

become read-only (protected from write, program and erase operations).

When Top Sector Lock (TSL) is connected to VCC, the top 256 pages of memory behave like

the other pages of memory.

Similar Part No. - M25PE10

Manufacturer	Part #	Datasheet	Description
STMicroelectronics	M25PE10-VMN6G	482Kb / 60P	1 and 2 Mbit, low voltage, Page-Erasable Serial Flash memories with Byte-Alterability, 50 MHz SPI bus, standard pinout
	M25PE10-VMN6P	482Kb / 60P	1 and 2 Mbit, low voltage, Page-Erasable Serial Flash memories with Byte-Alterability, 50 MHz SPI bus, standard pinout
	M25PE10-VMN6TG	480Kb / 37P	1 and 2 Mbit, Low Voltage, Page-Erasable Serial Flash Memories with Byte-Alterability, 33 MHz SPI Bus, Standard Pin-out
	M25PE10-VMN6TG	482Kb / 60P	1 and 2 Mbit, low voltage, Page-Erasable Serial Flash memories with Byte-Alterability, 50 MHz SPI bus, standard pinout
	M25PE10-VMN6TP	480Kb / 37P	1 and 2 Mbit, Low Voltage, Page-Erasable Serial Flash Memories with Byte-Alterability, 33 MHz SPI Bus, Standard Pin-out

More results

Similar Description - M25PE10

Manufacturer	Part #	Datasheet	Description
STMicroelectronics	M25PE20	482Kb / 60P	1 and 2 Mbit, low voltage, Page-Erasable Serial Flash memories with Byte-Alterability, 50 MHz SPI bus, standard pinout
Numonyx B.V	M25PE16	1Mb / 58P	16-Mbit, page-erasable serial flash memory with byte-alterability, 75 MHz SPI bus, standard pinout
	M25PE80	1Mb / 66P	8-Mbit, page-erasable serial flash memory with byte alterability, 75 MHz SPI bus, standard pinout
	M25PE40	1Mb / 62P	4 Mbit, page-erasable serial Flash memory with byte alterability, 75 MHz SPI bus, standard pinout
	M45PE10	990Kb / 47P	1-Mbit, page-erasable serial flash memory with byte-alterability and 75 MHz SPI bus interface
STMicroelectronics	M25PE20	480Kb / 37P	1 and 2 Mbit, Low Voltage, Page-Erasable Serial Flash Memories with Byte-Alterability, 33 MHz SPI Bus, Standard Pin-out
	M25PE16	492Kb / 56P	16 Mbit, low-voltage, Page-Erasable Serial Flash memory with byte-alterability, 50 MHz SPI bus, standard pinout
	M25PE40	482Kb / 60P	4 Mbit, low voltage, Page-Erasable Serial Flash memory with byte alterability, 50 MHz SPI bus, standard pinout
	M25PE80	507Kb / 61P	8 Mbit, low-voltage, Page-Erasable Serial Flash memory with Byte alterability, 50MHz SPI bus, standard pinout
	M45PE20	427Kb / 35P	2 Mbit, Low Voltage, Page-Erasable Serial Flash Memory With Byte-Alterability and a 25 MHz SPI Bus Interface

More results

M25PE10 Datasheet(PDF) 8 Page - Numonyx B.V

M25PE10 Datasheet(HTML) 8 Page - Numonyx B.V

Similar Part No. - M25PE10

Similar Description - M25PE10

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Download

Link URL