Electronic Components Datasheet Search |
|
M29W102 Datasheet(PDF) 2 Page - STMicroelectronics |
|
M29W102 Datasheet(HTML) 2 Page - STMicroelectronics |
2 / 20 page M29W102BT, M29W102BB 2/20 Figure 2. TSOP Connections DQ6 DQ3 DQ2 DQ13 DQ8 DQ7 DQ10 DQ9 A14 A8 A11 A10 A4 A15 A9 G A7 A2 DQ1 DQ0 A0 A1 A3 NC W E DQ14 RP VCC DQ15 AI02786 M29W102BT M29W102BB 10 1 11 20 21 30 31 40 VSS A13 A12 A6 A5 DQ11 DQ12 DQ5 DQ4 VSS Table 1. Signal Names A0-A15 Address Inputs DQ0-DQ15 Data Inputs/Outputs E Chip Enable G Output Enable W Write Enable RP Reset/Block Temporary Unprotect VCC Supply Voltage VSS Ground NC Not Connected Internally SUMMARY DESCRIPTION The M29W102B is a 1 Mbit (64Kb x16) non-vola- tile memory that can be read, erased and repro- grammed. These operations can be performed using a single low voltage (2.7 to 3.6V) supply. On power-up the memory defaults to its Read mode where it can be read in the same way as a ROM or EPROM. The memory is divided into blocks that can be erased independently so it is possible to preserve valid data while old data is erased. Each block can be protected independently to prevent accidental Program or Erase commands from modifying the memory. Program and Erase commands are writ- ten to the Command Interface of the memory. An on-chip Program/Erase Controller simplifies the process of programming or erasing the memory by taking care of all of the special operations that are required to update the memory contents. The end of a program or erase operation can be detected and any error conditions identified. The command set required to control the memory is consistent with JEDEC standards. The blocks in the memory are asymmetrically ar- ranged, see Tables 3 and 4, Block Addresses. The first or last 32 Kwords have been divided into four additional blocks. The 8 Kword Boot Block can be used for small initialization code to start the micro- processor, the two 4 Kword Parameter Blocks can be used for parameter storage and the remaining 16 Kwords are a small Main Block where the appli- cation may be stored. Chip Enable, Output Enable and Write Enable sig- nals control the bus operation of the memory. They allow simple connection to most micropro- cessors, often without additional logic. The memory is offered in a TSOP40 (10 x 14mm) package and it is supplied with all the bits erased (set to ’1’). |
Similar Part No. - M29W102 |
|
Similar Description - M29W102 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.NET |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |