Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833

603-778-2300 www.wallindustries.com Fax 603-778-9797

PSPRL9802D Series

Active PFC

200 Watt Dual Output

AC/DC Switching Power Supply

FEATURES

● 2 Year Warranty

● Optional Top Cover

● 90 ~ 264VAC Universal AC Input

● Approved to UL CUL TUV CE and CB

● Power Factor Corrected to EN61000-3-2 Class D

● 5V/ 12V/ 24V Dual Output Optional Combinations

● Compact 1U Size & Power Density: 5.2 Watts/cu in.

● Convection-Cooled and with Forced Air Cooling Rating Options

All specifications are based on 25

We reserve the right to change specifications based on technological advances.

INPUT SPECIFICATIONS

Input Voltage

90 – 264VAC Full Range

Input Frequency

47 to 63Hz

Input Current

4A at 100VAC full load

Inrush Current

35A max @ 110VAC with full load and cold start.

Leakage Current

1.5mA max @ 240VAC

Remote ON/OFF

Designated as REMO on the CN3, requires a low signal to inhibit output. Hiccup mode.

OUTPUT SPECIFICATIONS

Output Voltage

See Table

Output Power Range

200 Watts max.

Output Adjustability

Output user adjustable ±5% minimum.

Total Regulation

±5%

Output Current

See Table

Ripple & Noise (peak to peak)

±1%

Transient Response

Output voltage returns to within 1% in less than 500µs for a 50% dynamic load peak does not excess 5%.

Hold-Up Time

20ms min. at 80% of full load.

Overshoot

Turn-on/off not exceed 5% over nominal voltage.

Turn On Delay

1 second maximum at 120VAC.

PROTECTION

Over Voltage Protection

Latching down will occur when output voltage exceeds 130% and recycle AC input to reset.

Short Circuit Protection

Trip without damage and auto-recovery.

Over-Temperature Protection

Protected in the event of excessive operating ambient 85°C and automatic recovery.

Over-Power Protection

Hiccup mode 110-140%; auto-recovery.

Input Circuit Protection

A protected 250V/5A fuse inserted.

GENERAL SPECIFICATIONS

Efficiency

75% minimum (Measuring at 230Vand full load).

Withstand Voltage

1500 VAC input line to chassis (10mA DC cut off current, isolating 3000VAC primary to secondary

windings. Primary to core 1500VAC. All for 3 seconds.

Burn In

45 ±5°C for one hour @ 230VAC with full load.

PFC

Active power factor correction meets EN61000-3-2 class D.

Power Good

Designated as PG on the CN3 will go high 100-500ms after regulation and goes low 1ms before loss of

regulation.

Power Supply On

Green LED designated as LED 1 on the PCB.

Grounding Test

Apply 25A from ground pin of the three-prong plug to the far most earth. Max allowable resistance 0.1 ohm.