LB8659FN, LB8659PL

No.7899-4/16

[Remarks]

1) Specifies the IC standby leak current.

2) Specifies the output voltage when the constant voltage is output from pins OUT1 to OUT4.

3) Specifies the output transistor (upper and lower) saturation voltage at pins OUT1 to OUT4.

4) Specifies the current dissipated at the pin VB1. (IN1/2/3/4=H/L/L/L or L/H/L/L or L/L/H/L or L/L/L/H)

5) Specifies the current dissipated at the pin VB1. (IN1/2/3/4=H/L/H/L or H/L/L/H or L/H/H/L or L/H/L/H)

6) Specifies the output voltage when the constant voltage is output from pins OUT5 to OUT6.

7) Specifies the output transistor (upper and lower) saturation voltage at pins OUT5 to OUT6.

8) Specifies the current dissipated at the pin VB2.

9) Specifies the output voltage when the constant voltage is output from pins OUT7 to OUT8.

10) Specifies the output transistor (upper and lower) saturation voltage at pins OUT7 to OUT8.

11) Specifies the current dissipated at the pin VB1. (IN7/8=H/L or L/H)

12) Specifies the output current when the constant current is output from pins OUT9 to OUT10.

13) Specifies the output voltage variation caused by supply voltage fluctuation when the constant current is output

from pins OUT9 and OUT10.

14) Specifies the output transistor (upper and lower) saturation voltage at pins OUT9 to OUT10.

15) Specifies the saturation voltage of the IC pin discharge transistor.

16) Specifies the saturation voltage of the ICH pin discharge transistor. [LB8659FN only]

17) Specifies the current dissipated at the pin VB1. (IN9/10=H/L or L/H or H/H)

18) Specifies the output voltage at VREF.

19) Specifies the saturation voltage of the output transistor at pins ZMPR, ZMPI and AFPI.

20) Specifies the input current when the voltage input at pins IN1 to IN11 is “H”.

21) Specifies the input current when the voltage input at pins IN1 to IN11 is “L”

22) Specifies the overheat protection circuit detection temperature. (design guaranteed)

Package Dimensions

unit : mm

3293

[LB8659FN]