KDC_NMJC.G02 Page 5 of 6

www.murata-ps.com

NMJ Series

5.2kVDC Isolated 1W DC/DC Converters

OSCILLOSCOPE

Y INPUT

SUPPLY

C1 C2 C3

R1

T1

R2

Input

Output

DC/DC Converter

R LOAD

+

+

-

-

CHARACTERISATION TEST METHODS

Ripple & Noise Characterisation Method

Ripple and noise measurements are performed with the following test configuration.

C1

1uF X7R multilayer ceramic capacitor, voltage rating to be a minimum of 3 times the output voltage of the DC/DC converter

C2

10uF tantalum capacitor, voltage rating to be a minimum of 1.5 times the output voltage of the DC/DC converter with an ESR of less

than 100mΩ at 100 kHz

C3

100nF multilayer ceramic capacitor, general purpose

R1

450Ω resistor, carbon film, +/-1% tolerance

R2

50Ω BNC termination

T1

3T of the coax cable through a ferrite toroid

RLOAD

Resistive load to the maximum power rating of the DC/DC converter. Connections should be made via twisted wires

R3

50Ω resistor, carbon film, +/-1%

Measured values are multiplied by 10 to obtain the specified values.

Differential Mode Noise Test Schematic