H HiTRON

2008/04/14

HARMONIC CORRECTION (PFC) AC/DC MEDICAL APPLICATION

EXTERNAL DESKTOP ADAPTER UNIVERSAL INPUT

SINGLE OUTPUT 100 WATTS GREEN POWER

SWITCHING POWER SUPPLIES HEMP100G SERIES

SPECIFICATION

INPUT SPECIFICATION

Input Voltage: 90-264Vac typical.

Power Factor Correction (PFC) installed.

Input Connector: IEC320-3PL/2P AC receptacle.

Input Frequency: 50/60Hz.

Inrush Current: 7.2Arms @230Vac 50Hz.

Input Current: 0.976A@115Vac/0.496A@230Vac

Dielectric Withstand: Meet IEC60601-1.

EMI: Meet EN55011/FCC Class B.

Hold-up Time: 22mS @115Vac/ 43mS@230Vac typical.

Green Power: 0.37W @ 132Vac/ 0.50W @264Vac.

Earth Leakage: Less than 0.126mA.

FEATURES:

ACCOMMODATE UNIVERSAL AC INPUT

DESKTOP IEC320-3PL/2P AC RECEPTACLE

GREEN POWER DESIGN/MEET ENERGY

STAR(CEC) LVEVL IV.

MEET MEDICAL STANDARDS

EN60601-1/UL60601-1

EMI MEET EN55011/FCC CLASS B

GENERAL SPECIFICATION

Efficiency: 88-90% typical.

Switching Frequency: 40-65 KHz.

Circuit Topology: Fixed Flyback Circuit.

Transient Response: Output voltage returns in less than

1mS following a 25% load change.

Safety Standard: Meet Medical standards UL60601-1 /

EN60601-1Class I or II. Harmonic Current Emission,

EN61000-3-2 compliance.

Operating Temperature: 0 to +25/35/40°C

without derating. (various with output voltage)

Storage Temperature: -20 to +85°C.

Temperature Coefficient: 0.04%/°C typical.

Cooling: Free air convection.

Construction: Impact resistant plastic enclosure case.

Power Density: 4.56-5.5 Watts/Cubic inch.

Desktop Format.

NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.

(2) Load regulation is measured at 115Vac or 230Vac in percentage to indicate the change in output voltage as the load varied from half load to full load (

±%).

(3) The exact obtainable load regulation depends upon the output cord selected and load current. Upper data are for 6 ft. (2 m)cord AWG#18 wires.

(4)

Due to requests in market and advances in technology, specifications subject to change without notice.

OUTPUT SPECIFICATION

Output Voltage: See Ratings Chart.

Output Current: See Ratings Chart.

Output Wattage: 100 Watts.

Output Connector: Optional.

Line Regulation: 0.3 % typical.

Load Regulation: ± 2 % typical.

Tolerance: ±4%.

Noise & Ripple: 1% typical peak to peak.

OVP: Built-in. (Latch)

Adjustability: Not available.

Over Temp. Protection (OTP): Installed.

Overload Protection (OLP):

Fully protected against output overload and short circuit.

OLP set at about 110-135% rating output wattage.

Consult the factory for OLP setting.