X25650

3

the serial communication with the controller without

resetting the serial sequence. To pause, HOLD must

be brought LOW while SCK is LOW. To resume

communication, HOLD is brought HIGH, again while

SCK is LOW. If the pause feature is not used, HOLD

should be held HIGH at all times.

PRINCIPLES OF OPERATION

directly with the synchronous serial peripheral inter-

face (SPI) of many popular microcontroller families.

The X25650 contains an 8-bit instruction register. It is

accessed via the SI input, with data being clocked in on

the rising SCK. CS must be LOW and the HOLD and

WP inputs must be HIGH during the entire operation.

Table 1 contains a list of the instructions and their

opcodes. All instructions, addresses and data are

transferred MSB first.

Data input is sampled on the first rising edge of SCK

after CS goes LOW. SCK is static, allowing the user to

stop the clock and then resume operations. If the clock

line is shared with other peripheral devices on the SPI

bus, the user can assert the HOLD input to place the

X25650 into a “PAUSE” condition. After releasing

HOLD, the X25650 will resume operation from the

point when HOLD was first asserted.

Write Enable Latch

The X25650 contains a “write enable” latch. This latch

must be SET before a write operation will be

completed internally. The WREN instruction will set the

latch and the WRDI instruction will reset the latch. This

latch is automatically reset upon a power-up condition

and after the completion of a byte, page, or status

register write cycle.

Status Register

The RDSR instruction provides access to the status

register. The status register may be read at any time,

even during a write cycle. The status register is

formatted as follows:

7037 FRM T02

WPEN, BL0 and BL1 are set by the WRSR instruction.

WEL and WIP are read-only and automatically set by

other operations.

The Write-In-Process (WIP) bit indicates whether the

X25650 is busy with a write operation. When set to a

“1”, a write is in progress, when set to a “0”, no write is

in progress. During a write, all other bits are set to “1”.

The Write Enable Latch (WEL) bit indicates the status

of the “write enable” latch. When set to a “1”, the latch

is set, when set to a “0”, the latch is reset.

The Block Lock (BL0 and BL1) bits are nonvolatile and

allow the user to select one of four levels of protection.

The X25650 is divided into four 16384-bit segments.

One, two, or all four of the segments may be protected.

That is, the user may read the segments but will be

unable to alter (write) data within the selected

segments. The partitioning is controlled as illustrated

below.

7037 FRM T03

7

6

5

4

3

2

1

0

WPEN

X

X

X

BL1

BL0

WEL

WIP

Status Register Bits

Array Addresses

Protected

BL1

BL0

0

0

None

0

1

$1800–$1FFF

1

0

$1000–$1FFF

1

1

$0000–$1FFF

Table 1. Instruction Set

7037 FRM T04

*Instructions are shown MSB in leftmost position. Instructions are transferred MSB first.

Instruction Name

Instruction Format*

Operation

WREN

0000 0110

Set the Write Enable Latch (Enable Write Operations)

WRDI

0000 0100

Reset the Write Enable Latch (Disable Write Operations)

RDSR

0000 0101

Read Status Register

WRSR

0000 0001

Write Status Register

READ

0000 0011

Read Data from Memory Array beginning at selected address

WRITE

0000 0010

Write Data to Memory Array beginning at Selected Address (1 to 32

Bytes)