Real-Time Clocks

_____________________________________________________________________

7

SUPPLY CURRENT

vs. INPUT VOLTAGE

3.5

3.3

3.0

2.8

250

300

350

400

200

2.5

3.8

SUPPLY CURRENT

vs. TEMPERATURE

TEMPERATURE (

°C)

65

50

35

20

5

-10

-25

300

350

400

250

-40

80

OSCILLATOR FREQUENCY

vs. SUPPLY VOLTAGE

SUPPLY VOLTAGE (V)

5.0

4.5

4.0

3.5

3.0

32768.1

32768.2

32768.3

32768.4

32768.5

32768.6

32768.7

32768.0

2.5

5.5

Typical Operating Characteristics

Pin Description

PIN

24

28

NAME

FUNCTION

1

8

PWR

Active-Low Power-On Reset. This open-drain output pin is intended for use as an on/off

PWR can be

automatically activated from a kickstart input by the

KS pin or from a wake-up interrupt.

Once the system is powered on, the state of

PWR can be controlled by bits in the control

registers. The

PWR pin can be connected through a pullup resistor to a positive supply. For

5V operation, the voltage of the pullup supply should be no greater than 5.7V. For 3V

operation, the voltage on the pullup supply should be no greater than 3.9V.

2, 3

9, 10

X1, X2

Connections for Standard 32.768kHz Quartz Crystal. The internal oscillator circuitry is

12.5pF. Pin X1 is the input to the oscillator and can optionally be connected to an external

32.768kHz oscillator. The output of the internal oscillator, pin X2, is left unconnected if an

external oscillator is connected to pin X1. These pins are missing (N.C.) on the EDIP

package.

4–11

12–17,

19, 20

AD0–AD7

Multiplexed Bidirectional Address/Data Bus. The addresses are presented during the first

portion of the bus cycle and latched into the device by the falling edge of ALE. Write data is

latched by the rising edge of

WR. In a read cycle, the device outputs data during the latter

portion of the

RD low. The read cycle is terminated and the bus returns to a high-impedance

state as

RD transitions high.

12, 16

21, 22, 26

GND

Ground