Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.

Should a safety concern arise regarding this product, please be sure to contact us immediately.

Aluminum Electrolytic Capacitors/ HC

1.5

±0.2

2.0 max.

Terminal

(t=0.8)

4.0

±0.5

Top of spin

Standard terminal type does not require

terminal trimming peocess.

L+2.0 max.

Rated voltage etc. indicate to sleeve.

(10

.0)

10.

0±0.1

2-

φ2.0±0.1

Sleeve

Vent

Polarity bar

Recommended PWB piercing plan

0.8

+0.2

–0.1

(

φD)

● Endurance : 105 °C 2000 h

● 30 % smaller than series TS-HB

● RoHS directive compliant

Snap-in Type

Series:

Category Temp. Range

–40 °C to +105 °C

–25 °C to +105 °C

Rated W.V. Range

10 V.DC to 100 V.DC

160 V.DC to 250 V.DC

315 V.DC to 450 V.DC

Nominal Cap. Range820 µF to 100000 µF

150 µF to 3300 µF

39 µF to 1000 µF

Capacitance Tolerance

±20 % (120 Hz/+20 °C)

DC Leakage Current

3

CV (µA) max. After 5 minutes application of rated working voltage at +20 °C.

C : Capacitance (µF)

V: W.V. (V.DC)

tan

δ

Please see the attached standard products list

Frequency Correction

Factor for Ripple Current

Frequency (Hz)

50

60

100

120

500

1 k

10 k to

10 V.DC to 100 V.DC /C.F.

0.93

0.95

0.99

1.00

1.05

1.08

1.15

160 V.DC to 450 V.DC /C.F.

0.75

0.80

0.95

1.00

1.20

1.25

1.40

Endurance

After 2000 hours application of DC voltage with specified ripple current (

< rated DC working voltage)

at +105 °C±2 °C, the capacitors shall meet the following limits.

Capacitance change

< ±20 % of initial measured value

tan

δ

< 200 % of initial specified value

DC leakage current

< initial specified value

Shelf Life

After storage for 1000 hours at +105 °C±2 °C within no voltage applied and then being stabilized

at +20 °C, capacitors shall meet the limits specified in Endurance. (With voltage treatment)

(mm)

Jul. 2008