Everlight Electronics Co., Ltd.

http:\\www.everlight.com

Rev 4

Page: 7 of 9

Device No：DPT-091-008

Prepared date：07-20-2005

Prepared by：JAINE TSAI

PT91-21C

4.Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 280℃ for 3

seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more

intervals, and do soldering of each terminal. Be careful because the damage of the product is often

started at the time of the hand solder.

5.Repairing

Repair should not be done after the LEDs have been soldered. When repairing is

unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed

beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.