This Data Sheet may be revised by subsequent versions

©2004 Eon Silicon Solution, Inc.,

www.eonssi.com

or modifications due to changes in technical specifications.

7

EN25LF10

Rev. E, Issue Date: 2011/05/19

in this mode until another specific instruction (the Release from Deep Power-down Mode and Read

Device ID (RDI) instruction) is executed.

All other instructions are ignored while the device is in the Deep Power-down mode. This can be used

as an extra software protection mechanism, when the device is not in active use, to protect the device

from inadvertent Write, Program or Erase instructions.

Status Register.

The Status Register contains a number of status and control bits that can be read or

set (as appropriate) by specific instructions.

WIP bit.

The Write In Progress (WIP) bit indicates whether the memory is busy with a Write Status

Register, Program or Erase cycle.

WEL bit.

The Write Enable Latch (WEL) bit indicates the status of the internal Write Enable Latch.

BP2, BP1, BP0 bits.

The Block Protect (BP2, BP1, BP0) bits are non-volatile. They define the size of

the area to be software protected against Program and Erase instructions.

SRP bit / OTP_LOCK bit

The Status Register Protect (SRP) bit is operated in conjunction with the

Write Protect (WP#) signal. The Status Register Protect (SRP) bit and Write Protect (WP#) signal allow

the device to be put in the Hardware Protected mode. In this mode, the non-volatile bits of the Status

Register (SRP, BP2, BP1, BP0) become read-only bits.

In OTP mode, this bit is served as OTP_LOCK bit, user can read/program/erase OTP sector as normal

sector while OTP_LOCK value is equal 0, after OTP_LOCK is programmed with 1 by WRSR command,

the OTP sector is protected from program and erase operation. The OTP_LOCK bit can only be

programmed once.

Note :

In OTP mode, the WRSR command will ignore any input data and program OTP_LOCK bit to 1,

user must clear the protect bits before enter OTP mode and program the OTP code, then execute

WRSR command to lock the OTP sector before leaving OTP mode.

Write Protection

Applications that use non-volatile memory must take into consideration the possibility of noise and other

adverse system conditions that may compromise data integrity. To address this concern the EN25LF10

provides the following data protection mechanisms:

Power-On Reset and an internal timer (tPUW) can provide protection against inadvertent changes

while the power supply is outside the operating specification.

Program, Erase and Write Status Register instructions are checked that they consist of a number

of clock pulses that is a multiple of eight, before they are accepted for execution.

All instructions that modify data must be preceded by a Write Enable (WREN) instruction to set

the Write Enable Latch (WEL) bit . This bit is returned to its reset state by the following events:

– Power-up

– Write Disable (WRDI) instruction completion or Write Status Register (WRSR) instruction

completion or Page Program (PP) instruction completion or Sector Erase (SE) instruction

completion or Block Erase (BE) instruction completion or Chip Erase (CE) instruction

completion

The Block Protect (BP2, BP1, BP0) bits allow part of the memory to be configured as read-only.

This is the Software Protected Mode (SPM).

The Write Protect (WP#) signal allows the Block Protect (BP2, BP1, BP0) bits and Status Register

Protect (SRP) bit to be protected. This is the Hardware Protected Mode (HPM).

In addition to the low power consumption feature, the Deep Power-down mode offers extra

software protection from inadvertent Write, Program and Erase instructions, as all instructions are