132

Note: Part numbers are shown

for a single card of pre-printed

tags numbered 1-50.

0105660000

0269120000

0105420000

0437920000

0105620000

8/65/52.5 (.31/2.56/2.07)

8/65/48.5 (.31/2.56/1.91)

12 (.47)

300 V / 25 A / #22...8 AWG*

300 V / 25 A / #26...8 AWG

1.7 (16)

3.5

Type

Part No.

AP (1.5)

0146760000

AP (3.0)

0146720000

TW (1.5)

0242960000

TW (3.0)

0242920000

TW (0.5)

0474700000

TSch 2

0353660000

QL 2

0194300000

QL 3

0194400000

QL 4

0194500000

QL 10

0338300000

VH 12

0249000000

BS M 3 x 20 Cu

0377100000

QS 2

0270960000

QVS 2

0307300000

QVS 3

0329300000

QVS 4

0307400000

VH 19

0318000000

BS 25 bare

0334700000

QB 2

0205700000

QB 3

0205800000

QB 4

0205900000

QB 10

0343800000

PS 4

0299600000

SSP 3

0531760000

DEK 5/6

0468660001

DEK 5/6

0468760001

SAKT 1/LT

Slide Link

Disconnect Terminals

QL fixed

Final number indicates number of poles. See the Accessories Section

for more information.

SAKT 2/LT

0445420000

0437720000

0106020000

0330620000

0105920000

8/82/52.5 (.31/3.23/2.07)

8/82/48.5 (.31/3.23/1.91)

12 (.47)

300 V / 25 A / #22...8 AWG*

300 V / 25 A / #26...8 AWG

1.7 (16)

3.5

Type

Part No.

AP (1.5)

0146760000

AP (1.5)

0329120000

TW (1.5)

0242960000

TW (2.5)

0351820000

TW (0.5)

0474700000

TSch 2

0353660000

QL 2

0194300000

QL 3

0194400000

QL 4

0194500000

QL 10

0338300000

VH 12

0249000000

BS M 3 x 20 Cu 0377100000

QS 2

0270960000

QVS 2

0307300000

QVS 3

0329300000

QVS 4

0307400000

VH 19

0318000000

BS 25 bare

0334700000

QB 2

0205700000

QB 3

0205800000

QB 4

0205900000

QB 10

0343800000

PS 4

0299600000

SSP 3

0531760000

DEK 5/6

0468660001

DEK 5/6

0468760001

Slide Link

‡See Accessories section for additional information.

*For TS 35 #22...8 AWG

**With AP 380 V

Slide link disconnect terminals offer a superior

solution for simple current transformer circuits

and measurement transformer test sets using

SAKT 1/LT lateral disconnect terminals, or

SAKT 1/DU feed through terminals and

SAKT 1/QT cross disconnect terminals.

Current transformers must always have a

closed secondary circuit, even when changing

measuring equipment (see schematic below).

Stationary Jumpers

QL jumpers serve as fixed cross-connections

for the Disconnect Terminals. The QL jumpers

require the use of a fixing screw (BS M) and a

connection sleeve (VH) when attaching the

jumper to the current bar. The WQV jumpers

are provided with a retained jumper screw.

Sliding Jumpers

QS and QVS jumpers are sliding jumpers.

These jumpers are used to temporarily

connect or disconnect adjacent terminal

blocks. When the jumper screws are loose,

the jumper can move to either open or close

the cross connection between blocks.

Tightening the jumper screws holds the

jumper in either the open (disconnected)

or closed (shorted) position.

QB jumpers work in a similar manner except

that the jumpers remain fixed. An internal

sliding connection link connected to the

current bar either opens or closes the

connection based on whether the link

is in contact with the jumper or not.

SSP disconnect locks snap into the terminal

block. These locks must be removed to

change the position of the sliding link

connection.

QVS sliding

QB

L1

k

l

k

l

k

lL1

L2

L3

N

1

2

3

4

5

67

8

9

10

L2

L3

N

Terminal Block Selection Data

Available Options

Version

PA

2 StB test points PA

Back wall closed KrG

Back wall open KrG

4 StB 14 test points ø4.0 KrG 60 V**

1 StB 8.5 test point ø2.0 KrG

1 StB 8.5 test point ø2.3 KrG

2 StB 14 test points ø4 KrG

2 StB 14 test points ø2.3 KrG

Dimensions

Width / Length / Height mm (in.)

for TS 32

for TS 35

Insulation stripping length

mm (in.)

Technical Data

Rated voltage / rated current / wire size UL

CSA

VDE

Torque

Nm (lb. in.)

Clamping screw

M

End Plate (thickness mm)

PA

KrG

Partition (thickness mm)

PA

KrG

HP

Small Partition

Jumpers

Connection sleeve

Fixing screw

Connection sleeve

Fixing screw

Switchable Jumper Links

Test Plugs

Disconnect Lock

Marking Tags

Print

Consecutive horizontal

Consecutive vertical