PCAL9539A datasheet(1/48 Pages) NXP

Part #	PCAL9539A

Description	Low-voltage 16-bit I2C-bus and SMBus low power I/O port with interrupt and reset

Download	48 Pages

Scroll/Zoom	100%

Manufacturer	NXP [NXP Semiconductors]

Direct Link	http://www.nxp.com

Logo

1 / 48 page

1.

General description

The PCAL9539A is a low-voltage 16-bit General Purpose Input/Output (GPIO) expander

with interrupt and reset for I2C-bus/SMBus applications. NXP I/O expanders provide a

simple solution when additional I/Os are needed while keeping interconnections to a

minimum, for example, in ACPI power switches, sensors, push buttons, LEDs, fan control,

etc.

In addition to providing a flexible set of GPIOs, the wide VDD range of 1.65 V to 5.5 V

allows the PCAL9539A to interface with next-generation microprocessors and

microcontrollers where supply levels are dropping down to conserve power.

The PCAL9539A contains the PCA9539 register set of four pairs of 8-bit Configuration,

Input, Output, and Polarity Inversion registers, and additionally, the PCAL9539A has

Agile I/O, which are additional features specifically designed to enhance the I/O. These

additional features are: programmable output drive strength, latchable inputs,

programmable pull-up/pull-down resistors, maskable interrupt, interrupt status register,

programmable open-drain or push-pull outputs.

The PCAL9539A is a pin-to-pin replacement to the PCA9539 and PCA9539A, however,

the PCAL9539A powers up with all I/O interrupts masked. This mask default allows for a

board bring-up free of spurious interrupts at power-up.

The PCAL9539A open-drain interrupt (INT) output is activated when any input state differs

from its corresponding Input Port register state and is used to indicate to the system

master that an input state has changed.

INT can be connected to the interrupt input of a microcontroller. By sending an interrupt

signal on this line, the remote I/O can inform the microcontroller if there is incoming data

on its ports without having to communicate via the I2C-bus. Thus, the PCAL9539A can

remain a simple slave device.

The device outputs have 25 mA sink capabilities for directly driving LEDs while consuming

low device current.

The power-on reset sets the registers to their default values and initializes the device state

machine. In the PCAL9539A, the RESET pin causes the same reset/default I/O input

configuration to occur without de-powering the device, holding the registers and I2C-bus

state machine in their default state until the RESET input is once again HIGH. This input

requires a pull-up to VDD.

Two hardware pins (A0, A1) select the fixed I2C-bus address and allow up to four devices

to share the same I2C-bus/SMBus.

PCAL9539A

Low-voltage 16-bit I2C-bus and SMBus low power I/O port with

interrupt and reset

Rev. 1 — 3 October 2012

Product data sheet

Similar Part No. - PCAL9539A

Manufacturer	Part #	Datasheet	Description
NXP Semiconductors	PCAL9539A	727Kb / 8P	Smart, simple solutions for the 12 most common design concerns August 2011

More results

Similar Description - PCAL9539A

Manufacturer	Part #	Datasheet	Description
NXP Semiconductors	PCA9539	191Kb / 31P	16-bit I2C-bus and SMBus low power I/O port with interrupt and reset Rev. 05-28 July 2008
	PCA9539	168Kb / 21P	16-bit I2C and SMBus, low power I/O port with interrupt and reset 2004 Sep 30
	PCA9537	143Kb / 24P	4-bit I2C-bus and SMBus low power I/O port with interrupt and reset Rev. 05-7 May 2009
	PCA9535	190Kb / 32P	16-bit I2C-bus and SMBus, low power I/O port with interrupt Rev. 03-4 October 2007
	PCA9535	182Kb / 31P	16-bit I2C-bus and SMBus, low power I/O port with interrupt Rev. 05-15 September 2008
	PCA9538	169Kb / 28P	8-bit I2C-bus and SMBus low power I/O port with interrupt and reset Rev. 05-28 May 2009
	PCA9537DP.118	143Kb / 24P	4-bit I2C-bus and SMBus low power I/O port with interrupt and reset Rev. 05-7 May 2009
	PCA9539A	2Mb / 39P	Low-voltage 16-bit I2C-bus I/O port with interrupt and reset Rev. 1-26 September 2012
	PCAL9538A	2Mb / 43P	Low-voltage 8-bit I2C-bus and SMBus low power I/O port with interrupt, reset and Agile I/O Rev. 2-10 December 2012
	PCA9537	163Kb / 17P	4-bit I2C and SMBus low power I/O port with interrupt and reset 2004 Nov 29

More results

PCAL9539A Datasheet(PDF) 1 Page - NXP Semiconductors

PCAL9539A Datasheet(HTML) 1 Page - NXP Semiconductors

Similar Part No. - PCAL9539A

Similar Description - PCAL9539A

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Datasheet Download

Link URL