BD9701FP/CP-V5/T/T-V5,BD9703FP/CP-V5/T/T-V5,BD9702CP-V5/T/T-V5

Technical Note

9/16

www.rohm.com

2009.04- Rev.B

© 2009 ROHM Co., Ltd. All rights reserved.

●

Notes for PCB layout

Fig.30 Layout

• Place capacitors between VCC and Ground, and the Schottky diode as close as possible to the IC to reduce noise and

maximize efficiency.

• Connect resistors between INV and Ground, and the output capacitor filter at the same Ground potential in order to stabilize

the output voltage.

●

Application component selection and settings

Inductor L1

If the winding resistance of the choke coil is too high, the efficiency may deteriorate.

As the overcurrent protection operates over minimum 1.6A (BD9701FP/CP-V5/T/T-V5, BD9703FP/CP-V5/T-V5) or 3.2A

minimum (BD9701CP-V5/T/T-V5), attention must be paid to the heating of the inductor due to overload of short-circulated

load.

If you flow more than maximum current rating, coil will become overload, and cause magnetic saturation, and those

account for efficiency deterioration. Select from enough current rating of coil which doesn’t over peak current.

L1:inductor value, VCC:maximum input voltage, VOUT:output voltage, ⊿IL:coil ripple current value, fosc:oscillation

frequency

Shottky Barrier Diodes D1

A Schottky diode with extremely low forward voltage should be used. Selection should be based on the following

guidelines regarding maximum forward current, reverse voltage, and power dissipation:

・

・

The reverse voltage rating is higher than the VIN value.

・

Power dissipation for the selected diode must be within the rated level.

The power dissipation of the diode is expressed by the following formula:

Pdi=Iout(MAX)×Vf×(1-VOUT/VCC)

Iout (MAX): maximum load current, Vf: forward voltage, VOUT: output voltage, VCC: input voltage

Capacitor C1,C2,C3,C4,C5

As large ripple currents flow across C1 and C3 capacitors, high frequency and low impedance capacitor for a switching

regulator must be used. The ceramic capacitor C2 must be connected. If not, noise may cause an abnormal operation. If

the ripple voltage of input and output is large, C4 selected among ceramic , tantalum and OS capacitor with low ESR may

decrease the ripple, however if the only low ESR capacitor is used, an oscillation or unstable operation may be caused.

C5 is the capacitor for phase compensation and normally not used. If you need to improve the stability of feedback

network, connect C5 between INV and OUTPUT.

Feed back resistance R1,R2

The offset of output voltage is determined by both Feed back resistance and INV pin input current.

VOUT=(R1+R2) VINV/R2 (VINV pin Threshold Votage)

If Feed back resistance is high, the setting of output voltage will be move.

Recommended : Resistance between INV pin and GND = less than 10kΩ.

⊿IL

.

=

L1

(VCC-VOUT)

VOUT

VCC

fosc

1

×

×

4

5

2

3

1

INV

STBY

R2 : 1kO

R1 : 4kO

C5

VCC

OUT

GND

C2

5.0V

L1

D1

C3

C4

C1