Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.

Should a safety concern arise regarding this product, please be sure to contact us immediately.

Fixed Inductors (Voltage Step-up Coils)

Don’t Press

Wiring Tab

Precautions for use

1.Operation range and environments

1 These products are designed and manufactured for general and standard use in general electronic

equipment (e.g. AV equipment, home electric appliances, office equipment, information and communication

equipment)

2 These products are not intended for use in the following special conditions. Before using the products, carefully check

the effects on their quality and performance, and determine whether or not they can be used.

• In liquid, such as water, oil, chemicals, or organic solvent

• In direct sunlight, outdoors, or in dust

• In an environment where these products cause dew condensation

2. Handling

1 Do not bring magnets or magnetized materials close to the product. The influence of their magnetic field can

change the inductance value.

2 Do not apply strong mechanical shocks by either dropping or collision with other parts.

Excessive schock can damage the part.

3. Resoldering with a soldering iron

1 Resoldering should be done within 3 seconds by soldering iron, the temperature with 350 °C or less and should

be cooling down after ward. Both side of terminals shall be fixed closely to PWB. And terminals shall not be

pressed in heating.

Safety Precautions

(Common precautions for Voltage Step-up Coils)

• When using our products, no matter what sort of equipment they might be used for, be sure to make a written

agreement on the specifications with us in advance. The design and specifications in this catalog are subject

to change without prior notice.

• Do not use the products beyond the specifications described in this catalog.

• This catalog explains the quality and performance of the products as individual components. Before use, check

and evaluate their operations when installed in your products.

• Install the following systems for a failsafe design to ensure safety if these products are to be used in equipment

where a defect in these products may cause the loss of human life or other significant damage, such as damage to

vehicles (automobile, train, vessel), traffic lights, medical equipment, aerospace equipment, electric heating

appliances, combustion/gas equipment, rotating equipment, and disaster/crime prevention equipment.

✽ Systems equipped with a protection circuit and a protection device

✽ Systems equipped with a redundant circuit or other system to prevent an unsafe status in the event of a single fault

<Package markings>

Package markings include the product number, quantity, and country of origin.

In principle, the country of origin should be indicated in English.

2 The wiring tab shall not be held by sharp-edged tool.

3 Iron shall not be put to the component itself.

4. Mounting side

1 External force must be less than 4.9N while mounting.

2 The wiring tab is expose the terminal, so please be careful when you design PWB pattern of coil circumference.

5. Cleaning

If you clean the inductor, please use own your ultrasonic cleaning to check specified conditions.

6. Storage conditions

Normal temperature (–5 to 35 °C), normal humidity (85 % RH max.), shall not be exposed to direct sunlight and

harmful gases and care should be taken so as not to cause dew.

Sep. 2012

01

41