Datasheet

Datasheet

8/10

TSZ02201-0RBR0A300170-1-2

© 2012 ROHM Co., Ltd. All rights reserved.

25.Sep.2013 Rev.001

www.rohm.com

TSZ22111・15・001

BHxxMA3 series

●Operational Notes

1) Absolute maximum ratings

This product is produced with strict quality control, however it may be destroyed if operated beyond its absolute

maximum ratings. In addition, it is impossible to predict all destructive situations such as short-circuit modes, open

circuit modes, etc. T here f ore, it is i m port a n t to con s ider ci rcui t protection measures, li ke adding a

fuse, in case the IC is o perated in a special mo de exceeding the absolu t e maximum ra tings.

2) GND Potential

GND potential must be the lowest potential of all pins of the IC at all operating conditions. Ensure that no pins are at a

voltage below the ground pin at any time, even during transient condition.

3) Setting of Heat

Carry out the heat design that have adequate margin considering Pd of actual working states.

4) Pin Short and Mistake Fitting

When mounting the IC on the PCB, pay attention to the orientation of the IC. If there is mistake in the placement, the IC

may be burned up.

5) Actions in Strong Magnetic Field

Using the IC within a strong magnetic field may cause the IC to malfunction.

6) Mutual impedance

Use short and wide wiring tracks for the power supply and ground to keep the mutual impedance as small as

possible. Use a capacitor to keep ripple to a minimum.

7) STBY Pin Voltage

For standby mode, set STBY voltage below 0.3V. For normal operation, set the pin voltage beyond 1.5V. It is not

recommended to set STBY voltage between 0.3V and 1.5V, as it may cause malfunctions.

8) Over Current Protection Circuit

Over current and short circuit protection is built-in at the output, and IC destruction is prevented at the time of load

short circuit. These protection circuits are effective in the destructive prevention by the sudden accident. Please

avoid applications where the over current protection circuit operates continuously.

9) Thermal shutdown

This IC also features a thermal shutdown circuit that is designed to turn off the output when the junction temperature of

the IC exceeds about 170℃. This feature is intended to protect the IC only in the event of thermal overload and is not

designed to guarantee operation or act as an active security device for applications. Therefore, it is not recommended

that you design application where TSD will work in normal condition.

TSD ON TEMPURATURE(℃) (typ.)

HYSTERESIS TEMPURATURE(℃) (typ.）

BHxxMA3 series

170

15

10) Noise Pin

NOISE pin can drive small current, since it is directly connected to reference voltage circuit. The output voltage may

drop when the load of NOISE pin is more than 100nA. If the pin is connected to a capacitor, please use ceramic

capacitor for small leak current. Please take note that the output noise is smaller as NOISE pin capacitor is larger,

but startup time is longer.

11)Output capacitor

To prevent oscillation at output, it is recommended that the IC be operated at the stable region shown in Figure 12.

It operates at the capacitance value of more than 1.0

μF. As capacitance is larger, stability becomes more stable and

characteristic of output load fluctuation is also improved.