H

Series AS

Subminiature Slides

www.nkk.com

H4

Electrical Capacity (Resistive Load)

Logic Level:

0.4VA maximum @ 28V AC/DC maximum

(Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)

Note: Find additional explanation of operating range in Supplement section.

Other Ratings

Contact Resistance:

50 milliohms maximum

Insulation Resistance:

500 megohms minimum @ 500V DC

Dielectric Strength:

500V AC minimum for 1 minute minimum

Mechanical Life:

50,000 operations minimum

Electrical Life:

50,000 operations minimum

Nominal Operating Force:

2.55N

Contact Timing:

Nonshorting (break-before-make)

Travel:

Pretravel: .082” (2.1mm); Overtravel: .016” (0.4mm); Total Travel: .098” (2.5mm)

Materials & Finishes

Actuator:

Glass fiber reinforced polyamide

Upper Case Housing:

Carbon blended polyacetal (antistatic)

Lower Case Housing:

Glass fiber reinforced polyamide

Support Bracket:

Tin plated phosphor bronze

Movable Contact:

Phosphor bronze with gold plating

Stationary Contacts:

Brass with gold plating

Terminals:

Brass with gold plating

Environmental Data

Operating Temperature Range:

–30°C through +85°C (–22°F through +185°F)

Humidity:

90 ~ 95% humidity for 192 hours @ 40°C (104°F)

Vibration:

10 ~ 60Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range

& returning in 5 minutes; 3 right angled directions for 30 minutes

Shock:

PCB Processing

Soldering:

Wave Soldering Recommended. See Profile A in Supplement section.

Manual Soldering: for single pole see Profile B in Supplement section; for double pole see Profile A.

Cleaning:

These devices are not process sealed. Hand clean locally using alcohol based solution.

Standards & Certifications

The A Series slides have not been tested for UL recognition or CSA certification.

These switches are designed for use in a low-voltage, low-current, logic-level circuit.

When used as intended in a logic-level circuit, the results do not produce hazardous energy.