If you need further assistance after following this trouble-shooting procedure, contact Technical Service at

216-688-8300, extension 500 or at www.malloryracing.com for distributor related questions.

2

www.malloryracing.com

MALLORY IGNITION

MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP

10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144

216.688.8300

FAX 216.688.8306

FORM 1649M

04/05

Made in U.S.A.

Printed in U.S.A.

6. On distributors with the pickup separate from the

module assembly, you can check the pickup using

your Ohm meter. Connect the leads from your

Ohm meter to the 2 leads of the pickup. If you

show a resistance of 50 to 200 Ohms, the pickup is

functioning correctly. If the Ohm meter shows an

open circuit, the pickup should be replaced. Once

replaced, perform the module and pickup assembly

test procedure again as shown above.

5. Keeping your hands away from the coil leads, tap

the blade of your screwdriver to the metal strip of

the magnetic pickup assembly where you mea-

sured the air gap. Each time you tap the blade to

the metal strip, the light on your tester should flick-

er. If the light flickers off or on, your magnetic pick-

up and module are functioning correctly.