4D SYSTEMS

4.3” Bezel for the uLCD-43PT

© 2014 4D SYSTEMS

Page 4 of 6

www.4dsystems.com.au

3. Assembly of the uLCD-43PT onto the Bezel and on to the Panel

1) Place the uLCD-43PT face down into the bezel, taking care of the orientation of the display so the

mounting tabs of the display line up with the brass inserts in the bezel.

2) Insert 4 of the screws with 4 of the washers into the mounting tabs to secure the display on the bezel.

Nip the screws up but take care not to over tighten or damage may be done to the bezel.

3) Place the assembled bezel into the Panel/Enclosure, taking note of the orientation of the display.

4) Place a washer on one of the remaining screws, followed by a spring clip, and attach to one of the

brass inserted holes on the bezel, allowing the spring clip to work against the panel, holding the bezel

firmly in place.

5) Repeat for the remaining screws.

6) The bezel should now be securely fitted to the panel, and the uLCD-43PT should be securely fitted to

the bezel.

uLCD-43PT secured to the 4.3” Bezel, and Bezel secured to the Panel/Enclosure using the four spring clips