E3X-DAC-S

11

Do not use the product in atmospheres or environments that

exceed product ratings.

Amplifier Unit

● Designing

Operation after Turning Power ON

The Sensor is ready to detect within 200 ms after the power

supply is turned ON. If the Sensor and load are connected to

separate power supplies, be sure to turn ON the Sensor first.

Time may be required for the degree of match to stabilize after

the power supply is turned ON.

Operation When Turning Power OFF

Output pulses may occur when the power is turned OFF. Turn

OFF the power supply to the load and the load line before

turning OFF the power supply to the Sensor.

● Mounting

Connecting and Disconnecting Connectors

Mounting Connectors

1. Insert the Master or Slave Connector into the Amplifier Unit

until it clicks into place.

2. Attach the protector seals (provided as accessories) to the

sides of master and slave connectors that are not

connected.

Note: Attach the seals to the sides with grooves.

Removing Connectors

1. Slide the slave Amplifier Unit(s) for which the Connector is

to be removed away from the rest of the group.

2. After the Amplifier Unit(s) has been separated, press down

on the lever on the Connector and remove it. (Do not

attempt to remove Connectors without separating them

from other Amplifier Units first.)

Adding and Removing Amplifier Units

Adding Amplifier Units

1. Mount the Amplifier Units one at a time onto the DIN track.

2. Slide the Amplifier Units together, line up the clips, and

press the Amplifier Units together until they click into place.

Removing Amplifier Units

Slide Amplifier Units away from each other, and remove from

the DIN track one at a time. (Do not attempt to remove

Amplifier Units from the DIN track without separating them

first.)

Mounting the End Plate (PFP-M)

An End Plate should be used if there is a possibility of the

Amplifier Unit moving, e.g., due to vibration.

Precautions for Correct Use

Insert

Seal

Remove

Lever

Press down

Note 1. The specifications for ambient temperature will vary according to the

number of Amplifier Unit used together. For details, refer to Ratings

and Specifications on

2. Always turn OFF the power supply before joining or separating

Amplifier Units.

Click

into place

End Plate