Oplink Communications, Inc.

TRPNFEMM

All parameters guaranteed only at typical data rate

All parameters guaranteed only at typical data rate

Parameter

Symbol

Minimum

Typical

Maximum

Units

B

-

125

-

Mb/s

P

O

- 19.0

- 16.0

- 14.0

dBm

λ

C

1270

-

1380

nm

Δλ

RMS

-

140

-

nm

t

0.6

-

3.0

ns

Extinction Ratio

P

10

-

-

dB

Optical Output Power of OFF Transmitter

P

OFF

-

-

- 45.0

dBm

Duty Cycle Distortion Jitter (peak-to-peak)

DCD

-

-

1.0

ns

Data Dependent Jitter (peak-to-peak)

DDJ

-

-

0.6

ns

RJ

-

-

0.76

ns

Typically compliant with OC-3/STM-1 eye mask (GR-253-CORE

and G. 957) without filter, but not guaranteed and not tested for.

1

Data rate ranges from 50Mb/s to 266Mb/s. However, some degradation may be incurred in overall performance.

2

Measured average power coupled into 62.5/125μm, 0.275 NA graded-index multimode fiber. The minimum power specified is at Beginning-of-Life.

3

The Center Wavelength, Spectral Width and Optical Rise/Fall Time satisfy the trade-off curves in FDDI PMD document as shown in Figure 1.

4

Defined as 12.6 times the rms value per FDDI PMD.

5

Compliance with the Optical Pulse Envelope in FDDI PMD is not specified and is not claimed.

Parameter

Symbol

Minimum

Typical

Maximum

Units

B

-

125

-

Mb/s

P

min

- 32.5

- 34.5

-

dBm

P

max

- 14.0

0

-

dBm

LOS Thresholds

Increasing Light Input

P

los+

P

-

- 32.5

dBm

Decreasing Light Input

P

los-

- 45.0

-

-

LOS Hysteresis

-

1.5

-

-

dB

LOS Timing Delay

Increasing Light Input

t_loss_off

-

-

100

µs

Decreasing Light Input

t_loss_on

-

-

350

Contributed Duty Cycle Distortion Jitter (peak-to-peak)

DCD

-

-

0.4

ns

Contributed Data Dependent Jitter (peak-to-peak)

DDJ

-

-

1.0

ns

RJ

-

-

2.14

ns

Wavelength of Operation

λ

1100

-

1600

nm

1

Data rate ranges from 50Mb/s to 266Mb/s. However, some degradation may be incurred in overall performance.

2

and optimum sampling.

3

Defined as 12.6 times the rms value per FDDI PMD.

2

RevB-P.2009.06.23

Laser Safety: All transceivers are Class I Laser prod-

ucts per FDA/CDRH and IEC-60825 standards. They

must be operated under specified operating condi-

tions.

Oplink Communications, Inc.

DATE OF MANUFACTURE:

This product complies with

21 CFR 1040.10 and 1040.11

Meets Class I Laser Safety Requirements