1-441

60 V/0.7 Ohm,

General Purpose, 1 Form A,

Solid State Relay

Technical Data

HSSR-8060

• Telecommunication

Switching Equipment

• Reed Relay Replacement

• 28 Vdc, 24 Vac, 48 Vdc Load

Driver

• Industrial Relay Coil Driver

Description

The HSSR-8060 consists of a

high-voltage circuit, optically

coupled with a light emitting

diode (LED). This device is a

solid-state replacement for single-

pole, normally-open (1 Form A)

electromechanical relays used for

general purpose switching of

signals and low-power loads. The

relay turns on (contact closes)

with a minimum input current, I

of 5 mA through the input LED.

The relay turns off (contact

opens) with an input voltage, V

of 0.8 V or less. The detector

contains a high speed photosensi-

tive FET driver circuit and two

high voltage MOSFETs.

This relay’s logic level input con-

trol and very low typical output

on-resistance of 0.4

Ω makes it

suitable for both ac and dc loads.

Connection A, as shown in the

schematic, allows the relay to

switch either ac or dc loads.

Connection B, with the polarity

and pin configuration as indicated

in the schematic, allows the relay

to switch dc loads only. The

advantage of Connection B is that

the on-resistance is significantly

reduced, and the output current

capability increases by a factor of

two.

The electrical and switching char-

acteristics of the HSSR-8060 are

specified from -40

°C to +85°C.

Features

• Compact Solid-State

Bidirectional Switch

• Normally-Off Single-Pole

Relay Function (1 Form A)

• 60 V Output Withstand

Voltage in Both Polarities at

25

• 0.75/1.5 Amp Current

Ratings (See Schematic for

Connections A & B)

• Low Input Current; CMOS

Compatibility

• Very Low On-resistance:

0.4

• ac/dc Signal and Power

Switching

• Input-to-Output Momentary

Withstand Insulation

Voltage: 2500 Vac, 1 Minute

• 16-kV ESD Immunity: MIL-

STD-883, Method 3015

• IEEE Surge Withstand

Capability (IEEE STD

472-1974)

• CSA Approved

• UL 508 Approved

Applications

• Programmable Logic

Controllers

CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to

prevent damage and/or degradation which may be induced by ESD.

Functional Diagram

TRUTH TABLE

(POSITIVE LOGIC)

LED

ON

OFF

OUTPUT

L

H

H

5965-3575E