HY29F002T datasheet(2/38 Pages) HYNIX

Part #	HY29F002T

Description	2 Megabit (256K x 8), 5 Volt-only, Flash Memory

Download	38 Pages

Scroll/Zoom	100%

Manufacturer	HYNIX [Hynix Semiconductor]

Direct Link	http://www.skhynix.com/kor/main.do

Logo

2 / 38 page

2

Rev. 4.1/May 01

HY29F002T

BLOCK DIAGRAM

STATE

CONTROL

WE#

CE#

OE#

COMMAND

REGISTER

DQ[7:0]

V

CC DETECTOR

TIMER

ERASE VOLTAGE

GENERATOR AND

SECTOR SWITCHES

PROGRAM

VOLTAGE

GENERATOR

X-DECODER

Y-DECODER

2 MBIT

FLASH

MEMORY

ARRAY

(7 Sectors)

Y-GATING

DATA LATCH

I/O BUFFERS

I/O CONTROL

DQ[7:0]

A[17:0]

ELECTRONIC

ID

V

CC

V

SS

RESET#

HY29F002T has separate chip enable (CE#), write

enable (WE#) and output enable (OE#) controls.

The device is compatible with the JEDEC single

power-supply Flash command set standard. Com-

mands are written to the command register using

standard microprocessor write timings, from where

they are routed to an internal state-machine that

controls the erase and programming circuits.

Device programming is performed a byte at a time

by executing the four-cycle Program Command.

This initiates an internal algorithm that automati-

cally times the program pulse widths and verifies

proper cell margin.

The HY29F002T’s sector erase architecture allows

any number of array sectors to be erased and re-

programmed without affecting the data contents

of other sectors. Device erasure is initiated by

executing the Erase Command. This initiates an

internal algorithm that automatically preprograms

the array (if it is not already programmed) before

executing the erase operation. During erase

cycles, the device automatically times the erase

pulse widths and verifies proper cell margin.

To protect data in the device from accidental or

unauthorized attempts to program or erase the

device while it is in the system (e.g., by a virus),

the device has a Sector Protect function which

hardware write protects selected sectors. The

sector protect and unprotect features can be en-

abled in a PROM programmer. Temporary Sec-

tor Unprotect, which requires a high voltage, al-

lows in-system erasure and code changes in pre-

viously protected sectors.

Erase Suspend enables the user to put erase on

hold for any period of time to read data from, or

program data to, any sector that is not selected

for erasure. True background erase can thus be

achieved. The device is fully erased when shipped

from the factory.

Addresses and data needed for the programming

and erase operations are internally latched during

write cycles, and the host system can detect

completion of a program or erase operation by

reading the DQ[7] (Data# Polling) and DQ[6]

(toggle) status bits. Reading data from the device

is similar to reading from SRAM or EPROM de-

vices. Hardware data protection measures include

a low V

CC detector that automatically inhibits write

operations during power transitions.

The host can place the device into the standby

mode. Power consumption is greatly reduced in

this mode.

Similar Part No. - HY29F002T

Manufacturer	Part #	Datasheet	Description
Hynix Semiconductor	HY29F040A	282Kb / 40P	512K x 8-bit CMOS 5.0 volt-only, Sector Erase Flash Memory
	HY29F040AC-12	282Kb / 40P	512K x 8-bit CMOS 5.0 volt-only, Sector Erase Flash Memory
	HY29F040AC-12E	282Kb / 40P	512K x 8-bit CMOS 5.0 volt-only, Sector Erase Flash Memory
	HY29F040AC-12I	282Kb / 40P	512K x 8-bit CMOS 5.0 volt-only, Sector Erase Flash Memory
	HY29F040AC-15	282Kb / 40P	512K x 8-bit CMOS 5.0 volt-only, Sector Erase Flash Memory

More results

Similar Description - HY29F002T

Manufacturer	Part #	Datasheet	Description
ATMEL Corporation	AT29C020	426Kb / 17P	2-megabit (256K x 8) 5-volt Only Flash Memory
	AT49F002	182Kb / 16P	2-Megabit 256K x 8 5-volt Only Flash Memory
	AT49F002	213Kb / 20P	2-megabit (256K x 8) 5-volt Only Flash Memory
	AT29C020	257Kb / 11P	2-Megabit 256K x 8 5-volt Only CMOS Flash Memory
	AT49F020	84Kb / 10P	2-Megabit 256K x 8 5-volt Only CMOS Flash Memory
	AT49F002T	119Kb / 12P	2-Megabit 256K x 8 5-volt Only CMOS Flash Memory
	AT29LV020	387Kb / 16P	2-megabit (256K x 8) 3-volt Only Flash Memory
	AT29LV020	486Kb / 10P	2 Megabit 256K x 8 3-volt Only CMOS Flash Memory
	AT49F2048A	275Kb / 13P	2-megabit 256K x 8/ 128K x 16 5-volt Only CMOS Flash Memory
PMC-Sierra, Inc	PM29F002	148Kb / 21P	2 Megabit (256K X 8) 5.0 Volt-only CMOS Flash Memory

More results

HY29F002T Datasheet(PDF) 2 Page - Hynix Semiconductor

HY29F002T Datasheet(HTML) 2 Page - Hynix Semiconductor

Similar Part No. - HY29F002T

Similar Description - HY29F002T

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Datasheet Download

Link URL