408-32181

Rev B

3 of 5

5. Cycle the application tool to extract the pc board from the connector and cage assembly. Then retract

the ram, and carefully remove the extraction tool (with the connector and cage assembly) from the

wall supports.

5. MAINTENANCE AND INSPECTION

The extraction tool kit is inspected before shipment. It is recommended that the extraction tool kit be inspected

immediately upon arrival at your facility to ensure that it has not been damaged during shipment and that it

conforms to the dimensions provided in Figure 3.

5.1. Daily Maintenance

It is recommended that each operator be made aware of, and responsible for, the following steps of daily

maintenance:

1. Remove dust, moisture, and contaminants with a clean, soft brush or a lint-free cloth. DO NOT use

objects that could damage the extraction tool kits components.

2. When the extraction tool kit is not in use, store it in a clean, dry area.

5.2. Periodic Inspection

Regular inspections should be performed by quality control personnel. A record of scheduled inspections

should remain with the extraction tool kit or be supplied to personnel responsible for the extraction tool kit.

Inspection frequency should be based on amount of use, working conditions, operator training and skill, and

established standards.

6. REPLACEMENT AND REPAIR

Customer-replaceable parts are listed in Figure 3. A complete inventory should be stocked and controlled to

prevent lost time when replacement of parts is necessary. Parts other than those listed should be replaced by

TE Connectivity to ensure quality and reliability. Order replacement parts through your TE Representative, or

call 1-800-526-5142, or send a facsimile of your purchase order to 717-986-7605, or write to:

CUSTOMER SERVICE (038-035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105-3608

7. REVISION SUMMARY