Electronic Components Datasheet Search |
|
2102569-1 Datasheet(PDF) 1 Page - TE Connectivity Ltd |
|
2102569-1 Datasheet(HTML) 1 Page - TE Connectivity Ltd |
1 / 17 page 1 of 17 © 2015 TE Connectivity family of companies All Rights Reserved *Trademark TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners. PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com. Instruction Sheet 408-32087 26 JUN 15 Rev K CRIMPING DIE ASSEMBLY HYDRAULIC CRIMPING HEAD (Instruction Sheet) 68006-3 68007-3 68008-3 68009-3 68010-3 69066 (408-2453) 58422-1 (408-9535) 1752787-1 (408-8914) 1752877-1 (408-8956) --- 59877-3 68011-3 314948-3 58422-1 (408-9535) 1752787-1 (408-8914) Figure 1 1. INTRODUCTION The crimping die assemblies are designed to be installed into the hydraulic crimping heads listed in Figure 1 and are used to crimp pre-lubed COPALUM Lite sealed terminals and splices shown in Figure 2. The supports are designed to minimize crimp barrel and wire angle after crimping. Read these instructions thoroughly before crimping any terminals or splices. Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY. NOTE Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Illustrations and figures are for reference only and are not drawn to scale. 2. DESCRIPTION Each crimping die assembly consists of a stationary die (nest) and moving die (anvil), a nest wire support, an anvil wire support, and an anvil tongue support used only with 59877-3, 68009-3, 68010-3, 68011-3, and 314948-3. See Figure 1. The anvil tongue support is not used with 68006-3, 68007-3, 68008-3 die sets. 3. INSTALLATION 3.1. Support Installation DANGER To avoid personal injury, install the supports on the die outside of the crimping head. ALWAYS DISCONNECT electrical and air supply to the power unit before installing the hydraulic crimping head or supports. Crimping Die Assemblies and Supports for COPALUM* Lite Sealed Terminals and Splices Shank Nest Wire Support Tongue Support Tip Stationary Die (Nest) Tongue Support (Used ONLY with 59877-3, 68009-3, 68010-3, 68011-3, and 314948-3) Anvil Wire Support Moving Die Anvil Support Mounting Screw Shank |
Similar Part No. - 2102569-1 |
|
Similar Description - 2102569-1 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.NET |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |