Instruction Sheet

PRO-CRIMPER* III Hand Crimping

Tool Assembly 58612-1 with

408-4276

LOC B

1 of 5

E2009 Tyco Electronics Corporation, Harrisburg, PA

All International Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names used are the property of their respective owners.

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

19 MAY 09 Rev A

Die Assembly 58612-2

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume

applications. A wide selection of powered application equipment for extended-use, production operations is available.

Stationary Jaw

Back of Tool

(Wire Side)

Pivot Pin

PRO-CRIMPER III Hand

Crimping Tool Frame

354940-1 (408-9930)

Stationary Handle

Moving Handle

Locator Assembly

(Supplied with

Die Assembly)

Front of Tool

(Locator Side)

Die Assembly

Moving Jaw

Ratchet Adjustment Wheel

The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool

and is designed primarily for field installation, repair, maintenance work, or

prototyping in industrial, commercial, or institutional applications. Product

crimped with this tool will meet the crimp height requirement for hand tools in

the appropriate 114 series specification, but may not comply with other feature

parameters of the specification. Tyco Electronics offers a variety of tools to

satisfy your performance requirements. For additional information, contact the

Tooling Assistance Center at 1-800-722-1111.

C

Wire

TE Die

Part Number

TE Locator

Part Number{

Contact

Family}

Size

Insulation

Dia.

(mm [in.])

Strip Length

(mm [in.])

1.0

2.15

[.085]

58612-2

58515-1

MT2 Receptacles

0.6

1.90

[.075]

2.937 - 3.23

[.116 - .127]

0.35

1.40

[.055]

specific contact numbers.

Figure 1

1. INTRODUCTION

PRO–CRIMPER III Hand Crimping Tool

Assembly 58612–1 consists of Die Assembly

58612–2 and PRO–CRIMPER III Hand Crimping

Tool Frame 354940–1.

The die assembly consists of crimping dies and a

locator assembly.

Read these instructions thoroughly before crimping

any contacts.

Dimensions on this sheet are in millimeters [with

inch equivalents provided in brackets]. Figures

and illustrations are for identification only and are

not drawn to scale.

Reasons for revision can be found in Section 11,

REVISION SUMMARY.

NOTE

i