Instruction Sheet

PRO-CRIMPER* III Hand

Crimping Tool Assembly 91367-1

408-8777

LOC B

1 of 5

E2009 Tyco Electronics Corporation, Harrisburg, PA

All International Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names used are the property of their respective owners.

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

16 APR 09 Rev A

with Die Assembly 91367-2

PROPER USE GUIDELINES

Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume

applications. A wide selection of powered application equipment for extended-use, production operations is available.

The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool

and is designed primarily for field installation, repair, maintenance work, or

prototyping in industrial, commercial, or institutional applications. Product

crimped with this tool will meet the crimp height requirement for hand tools in

the appropriate 114 application specification, but may not comply with other

feature parameters of the specification. Tyco Electronics offers a variety of

tools to satisfy your performance requirements. For additional information,

contact the Tooling Assistance Center at 1-800-722-1111.

Locator Assembly

(Supplied with Die

Assembly)

Stationary Jaw

Back of Tool

(Wire Side)

Pivot Pin

PRO-CRIMPER III Hand

Crimping Tool Frame 354940-1

(See Instruction Sheet 408-9930)

Stationary Handle

Moving Handle

Ratchet

Adjustment

Wheel

Moving Jaw

Die Assembly

Front of Tool

(Locator Side)

DIE ASSEMBLY

LOCATOR ASSY

CONTACT

WIRE

PARTNUMBER

PARTNUMBER{

FAMILY}

SIZE (AWG)

INSUL DIA

STRIP LENGTH

91367-2

58515-1

1 mm System

Automotive Socket

Contacts

14-16

2.49-2.77

[.098-.109]

3.95-4.45

[.156-.175]

contact part numbers.

Figure 1

1. INTRODUCTION

PRO–CRIMPER III Hand Crimping Tool

Assembly 91367–1 consists of Die Assembly

91367–2 and PRO–CRIMPER III Hand Tool Frame

354940–1. The die assembly consists of crimping

dies and a locator assembly.

Read these instructions thoroughly before crimping

any contacts.

Dimensions given on this document are in

millimeters [with inch equivalents provided in

brackets]. Figures and illustrations are for

identification only and are now drawn to scale.

NOTE

i