©2010 Tyco Electronics Corporation, Berwyn, PA

All Rights Reserved

TE logo and Tyco Electronics are trademarks.

*Trademark. Other products, logos, and company names might be trademarks of their respective owners.

Instruction Sheet

TOOLING ASSISTANCE CENTER 1-800-722-1111

PRODUCT INFORMATION 1-800-522-6752

This controlled document is subject to change.

For latest revision and Regional Customer Service,

visit our website at www.tycoelectronics.com

1 of 1

LOC B

Figure 1

1. INTRODUCTION

Extraction Tool 58113-[ ] is used to extract a pin grid

array (PGA) substrate package (device) from a low

insertion force (LIF) PGA socket installed onto a

printed circuit (pc) board. Read these instructions

thoroughly before extracting any devices.

Dimensions in this instruction sheet are in

millimeters [with inches in brackets]. Figures are

not drawn to scale.

Reasons for reissue of this instruction sheet are

provided in Section 6, REVISION SUMMARY.

2. DESCRIPTION

Each tool features a handle and a tip with blades. See

Figure 1.

Make sure that all power to the system is "OFF"

before using the tool.

1. Insert the tip of the extraction tool (with the end

of the handle above the socket) between the

device and socket, then gently lift the handle until

that side of the device is raised from the socket.

Figure 2

2. Remove the extraction tool, then insert the tip

(as previously described) into the opposite side

of the assembly, then gently lift the handle until

that side of the device is raised from the socket.

3. Repeat this process for the remaining sides of

the assembly until the device is released from the

socket.

4. TOOL INSPECTION

Inspect the tool immediately upon arrival and at

regularly scheduled intervals according to Figure 3 to

ensure that the tool is not damaged.

Figure 3

5. REPLACEMENT

The extraction tool cannot be repaired. Order

replacement tools through your representative, or call

1-800-526-5142, or send a facsimile of your purchase

order to 717-986-7605, or write to:

CUSTOMER SERVICE (038-035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105-3608

6. REVISION SUMMARY

Revisions to this instruction sheet include:

requirements

NOTE

i

CAUTION

!

TOOL

NUMBER

OF BLADES

DIMENSION

A

B Typ

C Typ

58113-1

1.52 [.060] 2.54 [.100]

58113-3

10

58113-4

13

32.0 [1.26]

58113-5

16

39.6 [1.56]

Extraction Tool 58113-[ ]

408-9020

29 JUL 10 Rev B

Handle

Tip

Device

Socket

Tip of Tool

PC Board

Lift Tool Handle

81.3 [3.20]

76.2 [.30]

C

A

0.51 [.020]

B