408-9514

ExtractionTool 844751-1

Rev A

2 of2

Tyco Electronics Corporation

Figure 3

Mating Face

ofConnector

Tool Stop Against

Connector

Detail A

Detail B

Tool Tip Between Terminal

and Connector Locking Lance

Connector Locking

Lance Released from

Terminal

Push Tool and Tilt TipAway

From Locking Feature

Simultaneously

Pull Wire

DO NOT use excessive force when extracting a

terminal from its cavity. If there is difficulty in

removing the terminal, re-insert the tool tip,

making sure the tip is properly positioned in the

cavity; then repeat Steps 3 and 4.

4. INSPECTION AND REPLACEMENT

It is recommended that the tool be inspected

immediately upon arrival at your facility to ensure that

the tool has not been damaged during shipment and

that the tool conforms to the dimensions provided in

Figure 4.

Order replacement tools through your representative,

or call 1–800–526–5142, or send a facsimile of your

purchase order to 717–986–7605, or write to:

CUSTOMER SERVICE (038–035)

TYCO ELECTRONICS CORPORATION

PO BOX 3608

HARRISBURG PA 17105–3608

5. REVISION SUMMARY

Revisions to this instruction sheet include:

Figure 4

8.89+0.51/-0.25

[.35+.02/-.01]

31.8 [1.25]

76.2 [3.0]

11.18 [.44]

CAUTION

!