408- 9965

PRO- CRIMPER III Hand Crimping Tool Assembly 90870- 1

5

of 6

Rev C

Tyco Electronics Corporation

9. VISUAL INSPECTION

The crimping dies should be inspected on a regular

basis to ensure that they have not become worn or

damaged. Inspect the crimp sections for flattened,

chipped, worn, or broken areas. If damage or

abnormal wear is evident, the tool must be replaced.

See Section 10, REPLACEMENT.

10. REPLACEMENT

Customer--replaceable parts are shown in Figure 1.

Available separately, PRO--CRIMPER III Hand

Crimping Tool Repair Kit 679221--1 includes a

replacement nut and a variety of pins, rings, screws,

and springs.

If the dies are damaged or worn excessively, they

must be replaced.

Order the repair kit and replaceable parts through

your Tyco Electronics representative, or call

1--800--526--5142, or send a facsimile of your

purchase order to 1--717--986--7605, or write to:

CUSTOMER SERVICE (38--35)

TYCO ELECTRONICS

PO BOX 3608

HARRISBURG PA 17105--3608

11.REVISION SUMMARY

Revisions to this instruction sheet include:

S

Changed PRO--CRIMPER II Hand Tool to

PRO--CRIMPER III Hand Tool;

S

Changed Crimp--Height Comparator

information;

S

Updated format to current corporate

requirements;

S

Applied the TE logo; and

S

Added back page to illustrate tooling varieties

that accept Die Set Assembly 90870--2.