408-9167

Rev B

2 of 5

CABLE (RG/U)

CONNECTOR

HAND TOOL

PIN

SOCKET

142, 142A, 142B

228618-4

228596-4

69710-1

221980-2●

221981-2●

●50-Ohm Connector

Figure 2

Figure 3

4. Insert contact and cable into the dies so that stationary die indenter (crimper) starts entering the

crimping port of the contact. Visually align the other contact port hole over the movable die indenter

(crimper).

NOTE

Squeeze handles slowly until movable die indenter (crimper) enters crimping port.

5. Holding cable in place, actuate tool through a complete cycle.

6. Remove the crimped center contact from the tool.

3.2. Ferrule

1. Slide the ferrule over the two port holes of the contact until ferrule bottoms on connector body.

2. Insert the connector body into the front of the die assembly and into the locator, making sure locator

enters area between shoulder and spring of connector body. See Figure 3.

Pin Connector

Socket Connector

Connector Body

Support Sleeve

Ferrule

10.31 ±0.41

[.406 ±.016]

3.58 ±0.41

[.141 ±.016]

4.78 ±0.41

[.188 ±.016]

Cable Strip Lengths

Center-Contact Crimp

Ferrule Crimp

Front of Die

Ferrule

Locator

Ferrule Shoulder

Ferrule

Crimping

Area

Cable

Stationary

Indenter

Braid

Center Contact

Crimping Area

Cable

Movable

Indenter