409-10029

Stripping Module 1490503-[ ] and 1490501-[ ]

Rev C

8 of 31

Tyco Electronics Corporation

Figure 4

Rear View

Pneumatic

Assembly

Right

Guard

G

ripper

Pressure

Regulator

2. The gripper jaws then close on the wire while the strip blades close to cut through the insulation. The

stripping mechanism pulls the blades away from the operator to remove the insulation slug.

3. The stripping unit shifts to the “right side position” to remove the stripping blades from the applicator.

4. The terminator cycles to crimp a terminal onto the wire.

5. After completing the crimp, the grippers open to release the crimped wire and the stripping blades

retract.

6. The start sensor arm then retracts so that the air blast can blow the insulation slug into the scrap bin.

7. The stripping unit then transfers back to the start position.

3. RECEIVING INSPECTION AND INSTALLATION

3.1. Receiving Inspection

The stripping module is thoroughly inspected during and after assembly. A final series of inspections is made to

insure the proper machine functioning before packaging and shipping.

To protect against damage that may have occurred during shipment, remove the machine from the packaging

and carefully inspect the machine for damage. If damage is evident, file a claim against the carrier and

immediately notify Tyco Electronics.

To avoid personal injury, be sure to turn off" and disconnect power to the machine.

3.2. Installation of the Stripping Module Field Kit 1490503 -[ ] in Model G" Terminator

Remove the module from the packaging and install the field kit to the machine as follows:

A. AMP-O-LECTRIC Model G" Terminator Preparation

1. Disconnect electrical and pneumatic power supplies.

DANGER