GAMEWELL-FCI

12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118

Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.

©2013 by Honeywell International Inc. All rights reserved.

www.gamewell-fci.com

9021-60467 Rev. D page 1 of 4

Flex GF506R

Agent Release Control Panel

Reference Certificate

of Compliance

VMA-45894-02C

(Revision 1)

S624

SIGNALING

FM

APPROVED

7165-1703:0171

Features

•

Listed under UL Standard 864, 9th Edition.

•

IBC Seismic Certified.

•

Designed for Agent Releasing NFPA Standards: 12,

12A, 12B, 2001 and 2010.

•

Disable/Enable control per input zone and output zone.

•

Extensive transient protection.

•

Dual hazard operation.

•

Adjustable pre-discharge, discharge and waterflow

delay timers.

•

Cross-zone (double-interlock) capability.

•

Six programmable Style B (Class B) IDCs (Initiating

Device Circuit) with optional Class A wiring.

•

•

Four programmable Style Y (Class B) output circuits -

(special application power) with Style Z

(Class A) option.

•

Strobe Synchronization:

-

Cooper-Wheelock

-Gentex

- Faraday

- Amseco

•

Three programmable Form-C relays.

•

7.0 amps total 24 VDC output current.

•

Resettable and non-resettable output power.

•

Built-in Programmer.

Description

General

The Flex GF506R is a six-zone FACP used for single and

dual hazard agent releasing applications. The Flex

GF506R provides reliable fire detection. It also offers sig-

naling and protection for commercial, industrial, and insti-

tutional buildings that require agent-based releasing. The

tors.

transmit a maintenance trouble signal to the FACP that

indicates the need for cleaning. It also transmits a supervi-

sory ‘freeze’ signal when the ambient temperature falls

below the detector rating of approximately 45°F (7.22°C).

In addition, the Flex GF506R control panel is compatible

with the following conventional input devices:

•

two-wire and four-wire smoke detectors

•

pull stations

•

waterflow devices and tamper switches

•

other normally-open contact devices

For a complete listing of compatible devices, refer to the

Gamewell-FCI Device Compatibility Document,

P/N: 52195.

There are four outputs that are programmable as NACs

(Notification Appliance Circuits) or releasing circuits. Three

programmable Form-C relays (factory programmed for

Alarm, Trouble, and Supervisory), and the 24 VDC special

application resettable and non-resettable power outputs

are included on the main circuit board. The Flex GF506R

supervises all wiring, AC voltage, battery charger, and bat-

tery level.

The activation of a compatible smoke detector or any nor-

mally open fire alarm initiating device will do the following:

•

Turn on audible and visual signaling devices.

•

Light an indicator.

•

Display alarm information on the panel’s LCD.

•

Sound the piezo sounder at the FACP.

•

Activate the FACP alarm relay.

•

Operate an optional module used to notify a remote

station or initiate an auxiliary control function.

UL® is a registered trademark of Underwriter’s Laboratories Inc.

Flex GF506R