Electronic Components Datasheet Search |
|
5962-8947701PA Datasheet(PDF) 7 Page - Agilent(Hewlett-Packard) |
|
5962-8947701PA Datasheet(HTML) 7 Page - Agilent(Hewlett-Packard) |
7 / 11 page 7 Parameter Symbol Typ. Units Conditions Fig. Note I HYS 1.2 mA I HYS = ITH+ - ITH- Hysteresis 1 V HYS 1.1 V V HYS = VTH+ - VTH- Input Clamp Voltage V ILC -0.76 V V ILC = V2 - V3; V3 = GND; I IN = -10 mA Bridge Diode V D1,2 0.62 I IN = 3 mA (see schematic) Forward Voltage V D3,4 0.73 Input-Output Resistance R I-O 1012 Ω V I-O = 500 Vdc 9 Input-Output Capacitance C I-O 2.0 pF f = 1 MHz, V I-O = 0 Vdc Input Capacitance C IN 50 pF f = 1 MHz; V IN = 0 V, Pins 2 & 3, Pins 1 & 4 Open Output Rise Time t r 10 µs7 (10-90%) Output Fall Time t f 0.5 µs7 (90-10%) Typical Characteristics All typical values are at T A = 25 °C, V CC = 5 V, unless otherwise specified. Notes: 1. Maximum operating frequency is defined when output waveform (Pin 6) attains only 90% of VCC with RL = 1.8 k Ω, CL = 15 pF using a 5 V square wave input signal. 2. Measured at a point 1.6 mm below seating plane. 3. Current into/out of any single lead. 4. Surge input current duration is 3 ms at 120 Hz pulse repetition rate. Transient input current duration is 10 µs at 120 Hz pulse repetition rate. Note that maximum input power, PIN, must be observed. 5. Derate linearly above 100 °C free-air temperature at a rate of 4.26 mW/ °C. Maximum input power dissipation of 195 mW allows an input IC junction temperature of 150 °C at an ambient temperature of TA = 125°C with a typical thermal resistance from junction to ambient of θJAi = 235°C/W. The typical thermal resistance from junction to case is equal to 170 °C/W. Excessive PIN and TJ may result in device degradation. 6. The 1.8 k Ω load represents 1 TTL unit load of 1.6 mA and the 4.7 k Ω pull-up resistor. 7. Logic low output level at Pin 6 occurs under the conditions of VIN ≥ VTH+ as well as the range of VIN > VTH – once VIN has exceeded VTH+. Logic high output level at Pin 6 occurs under the conditions of VIN ≤ VTH- as well as the range of VIN < VTH+ once VIN has decreased below VTH-. 8. The ac voltage is instantaneous voltage. 9. Device considered a two terminal device: Pins 1, 2, 3, 4 connected together, Pins 5, 6, 7 8 connected together. 10. This is a momentary withstand test, not an operating condition. 11. The tPHL propagation delay is measured from the 2.5 V level of the leading edge of a 5.0 V input pulse (1 µs rise time) to the 1.5 V level on the leading edge of the output pulse (see Figure 7). 12. The tPLH propagation delay is measured from the 2.5 V level of the trailing edge of a 5.0 V input pulse (1 µs fall time) to the 1.5 V level on the trailing edge of the output pulse (see Figure 7). 13. Common mode transient immunity in Logic High level is the maximum tolerable dVCM/dt of the common mode voltage, VCM, to ensure that the output will remain in a Logic High state (i.e., VO > 2.0 V). Common mode transient immunity in Logic Low level is the maximum tolerable dVCM/dt of the common mode voltage, VCM, to ensure that the output will remain in a Logic Low state (i.e., VO < 0.8 V). See Figure 8. 14. In applications where dVCM/dt may exceed 50,000 V/ µs (such as static discharge), a series resistor, RCC, should be included to protect the detector IC from destructively high surge currents. The recommended value for RCC is 240 Ω per volt of allowable drop in VCC (between Pin 8 and VCC) with a minimum value of 240 Ω. 15. D1 and D2 are Schottky diodes; D3 and D4 are zener diodes. 16. Standard parts receive 100% testing at 25 °C (Subgroups 1 and 9). SMD, Class H and Class K parts receive 100% testing at 25, 125, and -55 °C (Subgroups 1 and 9, 2 and 10 ,3 and 11, respectively.) 17. Parameters shall be tested as part of device initial characterization and after process changes. Parameters shall be guaranteed to the limits specified for all lots not specifically tested. |
Similar Part No. - 5962-8947701PA |
|
Similar Description - 5962-8947701PA |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.NET |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |