 |
Electronic Components Datasheet Search |
|
|
Electronic Components Datasheet Search |
|
MAX98050EVSYS Datasheet(PDF) 3 Page - Maxim Integrated Products |
|
||||||||||||||||||||||||||||||
MAX98050EVSYS Datasheet(HTML) 3 Page - Maxim Integrated Products |
|
|
3 / 25 page  Maxim Integrated │ 3 www.maximintegrated.com Evaluates: MAX98050 MAX98050 Evaluation System Software Installation 1) For the latest software, login to your MyMaxim ac- count at maximintegrated.com and navigate to MAX98050 > Design Resources > Software. For the MAX98050, there are two GUIs available: MAX98050 Evaluation Software and Hearable Sound Studio Ba- sic. Download each, and extract each compressed folder by first selecting the folder, click and hold (or right-click) the folder, select Extract All, and then fol- low the instructions. 2) Install the MAX98050 Evaluation Software by running the program installer. Follow the installer prompts to completion. Windows might display a message in- dicating that this software is from an unknown pub- lisher. This is not an error condition and it is safe to proceed with the installation. 3) Install the Hearable Sound Studio Basic software on your computer by running the program installer. Follow the installer prompts to completion. Windows might display a message indicating that this software is from an unknown publisher. This is not an error condition and it is safe to proceed with the installation. Quick Start Guide For the MAX98050EVSYS#, there are two GUIs available: MAX98050 Evaluation Software and Hearable Sound Studio Basic. For this Quick Start, only the MAX98050 Evaluation Software will be used. Required Equipment ● MAX98050EVSYS# • Two MAX98050 Development Boards (only one needed for this Quick Start) • Audio Interface Board III (AUDINT3) • Dual EVKit Adapter Board • Micro-USB cable ● Windows 10 PC with USB port and USB audio source (e.g., Windows Media Player® or Apple Music®) Required Software ● MAX98050 Evaluation Software application. If not already installed, see the Software Installation section. Note: In the following sections, software-related items are identified by bolding. Text in bold refers to items directly from the evaluation software. Text in bold and under- lined refers to items from the Windows operating system. Reference Material ● MAX98050 IC data sheet Procedure Follow the steps below to set up the EV system for the device evaluation. 1) Connect the AUDINT3 Board to either one of the MAX98050 Development Boards using the J1 connector. 2) Verify jumper settings: JU1 Hardware Enable jumper is set to ENABLE, JMP1 ADDR is set to 0x64, JU2 MBVDD is set to 3.3V. 3) Connect the USB cable from your computer to the USB port (J2) on the AUDINT3 board. The AUDINT3 board provides all necessary power to the MAX98050 Development Board through the J1 connector. 4) When properly set up, there should be a slow puls- ing magenta on the AUDINT3’s LED (D1). When first plugged in, the LED D1 initially blinks white. Once the computer registers the AUDINT3 as a USB device, D1 changes to magenta and blinks slowly. Test 1) Launch the MAX98050 Evaluation Software and wait while the software connects to the EV system. 2) Once the connection is established, the status bar at the bottom of the GUI window should report Audio Interface 3 with its firmware version, and dis- play MAX98050 and its revision ID.After the EV system is fully connected, configure the device by loading a pre-installed configuration file.This file can be loaded from File, Load Register Settings, Pre-Installed Configuration Files. Scroll down to select the desired configuration file for USB playback to headphone output. Wait for the writes to complete before operating the device. Progress of the regis- ter writes can be seen in the Status Bar as a green progress bar. 3) Apply a headphone load to the OUTP and OUTN of J14, or OUTP and OUTN wire loops, or via the 3.5mm connector J9, see pinout in MAX98050 EV Kit Sche- matic Diagrams. Windows Media Player is a registered trademark and registered service mark of Microsoft Corporation. Apple Music is a registered trademark of Apple, Inc. |
Similar Part No. - MAX98050EVSYS |
|
Similar Description - MAX98050EVSYS |
|
|
|
Link URL |
| Privacy Policy |
| ALLDATASHEET.NET |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
allmanual.com |
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
