www.ti.com

Interrupt Handling

PCA9544A

WITH INTERRUPT LOGIC

SCPS146C – OCTOBER 2005 – REVISED OCTOBER 2006

INT3

INT2

INT1

INT0

D3

B2

B1

B0

COMMAND

X

X

X

X

X

0

X

X

No channel selected

X

X

X

X

X

1

0

0

Channel 0 enabled

X

X

X

X

X

1

0

1

Channel 1 enabled

X

X

X

X

X

1

1

0

Channel 2 enabled

X

X

X

X

X

1

1

1

Channel 3 enabled

No channel selected,

0

0

0

0

0

0

0

0

power-up default state

(1)

Only one channel may be selected at a time.

The PCA9544A provides four interrupt inputs (one for each channel) and one open-drain interrupt output. When

an interrupt is generated by any device, it is detected by the PCA9544A, and the interrupt output is driven low.

The channel does not need to be active for detection of the interrupt. A bit also is set in the control register (see

Table 2).

Bits 4–7 of the control register correspond to channels 0–3 of the PCA9544A, respectively. Therefore, if an

interrupt is generated by any device connected to channel 1, the state of the interrupt inputs is loaded into the

control register when a read is accomplished. Likewise, an interrupt on any device connected to channel 0

causes bit 4 of the control register to be set on the read. The master then can address the PCA9544A and read

the contents of the control register to determine which channel contains the device generating the interrupt. The

master can reconfigure the PCA9544A to select this channel and locate the device generating the interrupt and

clear it. Once the device responsible for the interrupt clears, the interrupt clears.

It should be noted that more than one device can provide an interrupt on a channel, so it is up to the master to

ensure that all devices on a channel are interrogated for an interrupt.

The interrupt inputs can be used as general-purpose inputs if the interrupt function is not required.

INT3

INT2

INT1

INT0

D3

B2

B1

B0

COMMAND

0

No interrupt on channel 0

X

X

X

X

X

X

X

1

Interrupt on channel 0

0

No interrupt on channel 1

X

X

X

X

X

X

X

1

Interrupt on channel 1

0

No interrupt on channel 2

X

X

X

X

X

X

X

1

Interrupt on channel 2

0

No interrupt on channel 3

X

X

X

X

X

X

X

1

Interrupt on channel 3

(1)

Several interrupts can be active at the same time. For example, INT3 = 0, INT2 = 1, INT1 = 1, INT0 = 0 means that there is no interrupt

on channels 0 and 3, and there is interrupt on channels 1 and 2.

6

Submit Documentation Feedback