MBM29LV400BC-70PW datasheet(3/58 Pages) SPANSION

Part #	MBM29LV400BC-70PW

Description	FLASH MEMORY CMOS 4M (512K X 8/256K X 16) BIT

Download	58 Pages

Scroll/Zoom	100%

Manufacturer	SPANSION [SPANSION]

Direct Link	http://www.spansion.com

Logo

3 / 58 page

MBM29LV400TC-55/70/90/MBM29LV400BC-55/70/90

3

s

s GENERAL DESCRIPTION

The MBM29LV400TC/BC are a 4M-bit, 3.0 V-only Flash memory organized as 512K bytes of 8 bits each or 256K

words of 16 bits each. The MBM29LV400TC/BC are offered in a 48-pin TSOP(1), 44-pin SOP, 48-pin CSOP,

and 48-ball FBGA packages. These devices are designed to be programmed in-system with the standard system

3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The devices can also

be reprogrammed in standard EPROM programmers.

The standard MBM29LV400TC/BC offer access times 70 ns and 120 ns, allowing operation of high-speed

microprocessors without wait states. To eliminate bus contention the devices have separate chip enable (CE),

write enable (WE), and output enable (OE) controls.

The MBM29LV400TC/BC are pin and command set compatible with JEDEC standard E2PROMs. Commands

are written to the command register using standard microprocessor write timings. Register contents serve as

input to an internal state-machine which controls the erase and programming circuitry. Write cycles also internally

latch addresses and data needed for the programming and erase operations. Reading data out of the devices

is similar to reading from 5.0 V and 12.0 V Flash or EPROM devices.

The MBM29LV400TC/BC are programmed by executing the program command sequence. This will invoke the

Embedded Program Algorithm which is an internal algorithm that automatically times the program pulse widths

and verifies proper cell margin. Typically, each sector can be programmed and verified in about 0.5 seconds.

Erase is accomplished by executing the erase command sequence. This will invoke the Embedded Erase

Algorithm which is an internal algorithm that automatically preprograms the array if it is not already programmed

before executing the erase operation. During erase, the devices automatically time the erase pulse widths and

verify proper cell margin.

A sector is typically erased and verified in 1.0 second. (If already completely preprogrammed.)

The devices also feature a sector erase architecture. The sector mode allows each sector to be erased and

reprogrammed without affecting other sectors. The MBM29LV400TC/BC are erased when shipped from the

factory.

The devices feature single 3.0 V power supply operation for both read and write functions. Internally generated

and regulated voltages are provided for the program and erase operations. A low VCC detector automatically

inhibits write operations on the loss of power. The end of program or erase is detected by Data Polling of DQ7,

by the Toggle Bit feature on DQ6, or the RY/BY output pin. Once the end of a program or erase cycle has been

completed, the devices internally reset to the read mode.

Fujitsu’s Flash technology combines years of EPROM and E2PROM experience to produce the highest levels

of quality, reliability, and cost effectiveness. The MBM29LV400TC/BC memories electrically erase the entire chip

or all bits within a sector simultaneously via Fowler-Nordhiem tunneling. The bytes/words are programmed one

byte/word at a time using the EPROM programming mechanism of hot electron injection.

Similar Part No. - MBM29LV400BC-70PW

Manufacturer	Part #	Datasheet	Description
Fujitsu Component Limit...	MBM29LV400BC-70PBT	584Kb / 58P	4M (512K X 8/256K X 16) BIT
	MBM29LV400BC-70PCV	584Kb / 58P	4M (512K X 8/256K X 16) BIT
	MBM29LV400BC-70PF	584Kb / 58P	4M (512K X 8/256K X 16) BIT
	MBM29LV400BC-70PFTN	584Kb / 58P	4M (512K X 8/256K X 16) BIT
	MBM29LV400BC-70PFTR	584Kb / 58P	4M (512K X 8/256K X 16) BIT

More results

Similar Description - MBM29LV400BC-70PW

Manufacturer	Part #	Datasheet	Description
SPANSION	MBM29F400TC	566Kb / 48P	FLASH MEMORY CMOS 4M (512K x 8/256K x 16) BIT
Winbond	W28V400B	1Mb / 48P	4M(512K x 8/256K x 16) SMARTVOLTAGE FLASH MEMORY
Fujitsu Component Limit...	MBM29F040A-12	715Kb / 18P	FLASH MEMORY CMOS 4M 512K X 8 BIT
Macronix International	MX29LV400T	1Mb / 59P	4M-BIT [512K x 8 / 256K x 16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY
Toshiba Semiconductor	TC58FVT004	1Mb / 26P	4M (512K x 8) BIT CMOS FLASH MEMORY
Macronix International	MX28F4100	175Kb / 2P	4M-BIT (512K X 8) CMOS FLASH MEMORY
	MX29LV401T	986Kb / 56P	4M-BIT [512K x 8 / 256K x 16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY
	MX29LV400CT	888Kb / 68P	4M-BIT [512K x 8 / 256K x 16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY
	MX27C4100	785Kb / 18P	4M-BIT [512K x 8/256K x 16] CMOS EPROM
Fujitsu Component Limit...	MBM29LV400TC	584Kb / 58P	4M (512K X 8/256K X 16) BIT

More results

MBM29LV400BC-70PW Datasheet(PDF) 3 Page - SPANSION

MBM29LV400BC-70PW Datasheet(HTML) 3 Page - SPANSION

Similar Part No. - MBM29LV400BC-70PW

Similar Description - MBM29LV400BC-70PW

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Datasheet Download

Link URL