www.ti.com

ABSOLUTE MAXIMUM RATINGS

RECOMMENDED OPERATING CONDITIONS

ELECTROSTATIC DISCHARGE PROTECTION

SN65HVD30 – SN65HVD39

SLLS665C – SEPTEMBER 2005 – REVISED JULY 2006

UNIT

Supply voltage range

–0.3 V to 6 V

Voltage range at any bus terminal (A, B, Y, Z)

–9 V to 14 V

Voltage input, transient pulse through 100

–50 to 50 V

Input voltage range (D, DE, RE)

-0.5 V to 7 V

Continuous total power dissipation

Output current (receiver output only, R)

11 mA

(1)

Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings

only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating

conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

(2)

All voltage values, except differential I/O bus voltages, are with respect to network ground terminal.

(3)

This tests survivability only and the output state of the receiver is not specified.

(4)

The thermal shutdown protection circuit internally limits the continuous total power dissipation. Thermal shutdown typically occurs when

the junction temperature reaches 165

°C.

over operating free-air temperature range unless otherwise noted

MIN

NOM

MAX

UNIT

Supply voltage

3

3.6

V

Voltage at any bus terminal (separately or common mode)

12

SN65HVD30, SN65HVD33, SN65HVD36, SN65HVD38

25

Signaling rate

SN65HVD31, SN65HVD34, SN65HVD37, SN65HVD39

5

Mbps

SN65HVD32, SN65HVD35

1

Differential load resistance

54

60

Ω

High-level input voltage

D, DE, RE

2

Low-level input voltage

D, DE, RE

0

0.8

V

Differential input voltage

–12

12

Driver

–60

High-level output current

mA

Receiver

–8

Driver

60

Low-level output current

mA

Receiver

8

Ambient still-air temperature

–40

85

°C

(1)

The algebraic convention, in which the least positive (most negative) limit is designated as minimum is used in this data sheet.

PARAMETER

TEST CONDITIONS

MAX

UNIT

Human body model

Bus terminals and GND

±16

All pins

±4

kV

All pins

±1

(1)

All typical values at 25°C with 3.3-V supply.

(2)

Tested in accordance with JEDEC Standard 22, Test Method A114-A.

(3)

Tested in accordance with JEDEC Standard 22, Test Method C101.

3

Submit Documentation Feedback