TS5204

150mA Low Noise LDO Voltage Regulator

2/6

Version: A07

Parameter

Conditions

Min

Typ

Max

Unit

0.97|Vo|

1.03|Vo|

Output Voltage

0.96|Vo|

1.04|Vo|

V

Output Voltage Temp. Coefficient

(Note 4)

--

50

--

ppm/

Line Regulation

--

0.1

0.5

%

Load Regulation (Note 5)

0.1mA ≤ Io ≤ 120mA

--

1

2

%

Io=100uA

--

20

--

Io=50mA

--

250

300

Io=120mA

--

350

400

Dropout Voltage (Note 6)

Io=150mA (5V version)

--

450

500

mV

Io=100uA

--

110

150

Io=50mA

--

500

1000

Io=120mA

--

2600

3100

Ground Pin Current (Note 7)

Io=150mA (5V version)

--

3500

4200

uA

Output Current Limit

150

200

--

mA

Power Supply Rejection Ratio

At f=100Hz, Io=100uA,

--

75

--

dB

Thermal Regulation (Note 8)

--

0.05

--

%/W

Output Noise

--

260

--

nV√Hz

Note:

1. Exceeding the absolute maximum rating may damage the device.

allowable power dissipation will result in excessive die temperature, and the regulator will go into thermal shutdown.

3. The device is not guaranteed to function outside its operating rating.

4: Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature

range.

5: Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are tested for

in output voltage due to heating effects are covered by the thermal regulation specification.

6: Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal

value measured at 1V differential.

7: Ground pin current is the regulator quiescent current plus pass transistor base current. The total current drawn from

the supply is the sum of the load current plus the ground pin current.

8: Thermal regulation is defined as the change in output voltage at a time “t” after a change in power dissipation is