11/36

M36W108AT, M36W108AB

Note: 1. Logic level ‘1’ is High, ‘0’ is Low. -0-1-0-0-0-1-1-1-0- represent bit value in successive Read operations.

DQ

Name

Logic Level

Definition

Note

7

Data

Polling

‘1’

Erase Complete or erase block

in Erase Suspend

Indicates the P/E.C. status, check during

Program or Erase, and on completion before

checking bits DQ5 for Program or Erase

Success.

‘0’

Erase On-going

DQ

Program Complete or data of

non erase block during Erase

Suspend

DQ

Program On-going

6

Toggle Bit

‘-1-0-1-0-1-0-1-’

Erase or Program On-going

Successive reads output complementary

data on DQ6 while Programming or Erase

operations are on-going. DQ6 remains at

constant level when P/E.C. operations are

completed or Erase Suspend is

acknowledged.

DQ

Program Complete

‘-1-1-1-1-1-1-1-’

Erase Complete or Erase

Suspend on currently

addressed block

5

Error Bit

‘1’

Program or Erase Error

This bit is set to ‘1’ in the case of

Programming or Erase failure.

‘0’

Program or Erase On-going

4

Reserved

3

Erase

Time Bit

‘1’

Erase Timeout Period Expired

P/E.C. Erase operation has started. Only

possible command entry is Erase Suspend

(ES).

‘0’

Erase Timeout Period

On-going

An additional block to be erased in parallel

can be entered to the P/E.C.

2

Toggle Bit

‘-1-0-1-0-1-0-1-’

Chip Erase, Erase or Erase

Suspend on the currently

addressed block.

Erase Error due to the

currently addressed block

(when DQ5 = ‘1’)

Indicates the erase status and allows to

identify the erased block.

‘1’

Program on-going, Erase

on-going on another block or

Erase Complete

DQ

Erase Suspend read on non

Erase Suspend block

1

Reserved

0

Reserved