TEWS TECHNOLOGIES GmbH
Am Bahnhof 7
25469 Halstenbek / Germany
Phone: +49-(0)4101-4058-0
Fax: +49-(0)4101-4058-19
e-mail: info@tews.com
www.tews.com
TEWS TECHNOLOGIES LLC
1 E. Liberty Street, Sixth Floor
Reno, Nevada 89504 / USA
Phone: +1 (775) 686 6077
Fax: +1 (775) 686 6024
e-mail: usasales@tews.com
www.tews.com
The Embedded I/O Company
TEWS TECHNOLOGIES GmbH keeps the right to change technical specification without further notice
06/2002
IndustryPack is a registered trademark of SBS Technologies, Inc.
Application Information
The TIP250 is an IndustryPack
compatible module that
offers an easy and reliable way to implement 8 Mbytes of
Flash memory. The TIP250 is ideal for holding application
code, operating system software or data.
Two AM29LV033 devices (32Mbit, x8 organized) are used
to provide 1 bank of 8 Mbytes (16 bit wide) Flash memory
which is divided into 64 sectors of 128 Kbytes (16 bit wide).
Accesses to the TIP250 Flash memory occur within the IP
memory space. After power-on the TIP250 comes up in
read only mode. The IP I/O space holds the Flash Control
Register and the interrupt vector register.
ID-PROM
Local +3.3V
32 Mbit FLASH
(4Mbyte)
Local
Control
Logic
32 Mbit FLASH
(4Mbyte)
Bank1
8 Mbytes FLASH
64 sectors of 128Kbytes
16 bit wide
For
First-Time-Buyers
the
engineering
documentation
TIP250-ED
is
recommended.
The
engineering
documentation includes TIP250-DOC, schematics and data
sheets.
Driver support (TIP250-SW-xx) is available for different
operating systems.
Technical Information
! Interface according to IndustryPack specification
! Identification-PROM supports auto-configuration
! Single Size IndustryPack
! 8 Mbytes of Flash Memory
! Organized in 1 bank of 8 Mbytes (16 bit wide), 64
sectors of 128 Kbytes (16 bit wide)
! Flash chip: 2 x AM29LV033, 90 ns, TSOP package
! Guaranteed min. erase and program cycle endurance:
1.000.000 cycles
! Typical bank erase time: 45 s
! Typical sector erase time: 0.7 s
! Typical word programming time: 9 µs
! Typical bank programming time: 36 s
! Interrupt support on program / erase cycles
! Power requirements: +5V only, on board +3.3V
generation
! No connections to IP-I/O connector
! Operating temperature -40°C to +85°C
Order Information
TIP250-10
8 Mbytes Flash Memory
TIP250-DOC
User Documentation
TIP250-ED
Engineering Documentation, includes
TIP250-DOC
TIP250-SW-12
OS-9 Software Support
TIP250-SW-32
pSOS Software Support
TIP250-SW-42
VxWorks Software Support
TIP250-SW-62
Windows NT 4.0 Software Support
TIP250-SW-72
LynxOS Software Support
TIP250-SW-82
LiNUX Software Support
TIP250-SW-92
QNX 4 Software Support
TIP250-SW-95
QNX 6 Software Support
TIP250 8 Mbytes Flash Memory