TECHNICAL DATASHEET

LANC4815W12

(888) 597-WALL

www.wallindustries.com

Page 5 of 14

Thermal Consideration

The power module operates in a variety of thermal environments. However, sufficient cooling should be

provided to help ensure reliable operation of the unit. Heat is removed by conduction, convention, and radiation

to the surrounding environment. Proper cooling can be verified by measuring the point as the figure below. The

temperature at this location should not exceed 105°C. When operating, adequate cooling must be provided to

maintain the test point temperature at or below 105°C. Although the maximum point temperature of the power

modules is 105°C, you can limit this temperature to a lower value for extremely high reliability.

Remote ON/OFF Control

The positive logic remote ON/OFF control circuit is included.

Turns the module ON during a logic High on the On/Off pin and turns OFF during a logic Low. The On/Off pin

is an open collector/drain logic input signal (Von/off) that’s referenced to GND. If not using the Remote On/Off

feature, please open circuit between on/off pin and –input pin to turn the module on.

Remote ON/OFF Implementation

Figure 4

Figure 5

TOP VIEW

Figure 3

Measurement shown in inches and millimeters

Isolated-Closure Remote ON/OFF

Level Control using TTL Output

Level Control using Line Voltage

Figure 6